Victor Thermal Dynamics
Victor Thermal Dynamics 0381-1484 Straight Cutting Torch 21 in 180deg Head
Straight cutting torch with 180-degree head, 21 in length, cuts up to 8 in using oxygen and all fuel gases with proper tip
- TypeWelding Supplies
- Cuts up to 8 in with Victor 1 Series tips
- 180-degree head angle improves access in tight joints
- 21 in length gives extended reach for heavy cuts
- Compatible with oxygen and all fuel gases using proper tip
- 9/16-18 RH and LH inlet connections fit standard regulators
Victor Straight Cutting Torch 21 in
The Victor 0381-1484 is a straight cutting torch designed for oxygen and all fuel gases when paired with the correct cutting tip. It belongs to the Victor ST2600FC series and carries a 180-degree head angle for straight-line cutting tasks. The unit measures 21 inches in length and connects via 9/16-18 RH and LH inlet fittings. This torch is built for cutting only and cannot be used for oxy-fuel welding.
Sustained Cutting Capacity 8 in
Under continuous operation the torch cuts material up to 8 inches thick when the proper tip from the Victor 1 Series is fitted. The 180-degree head maintains a fixed orientation so the flame stays aligned during long passes without the need to reposition the handle. Because the design is limited to cutting service, operators running extended weld jobs must switch to a dedicated welding torch. The fixed head angle also means the tool cannot be adjusted for angled or overhead cuts without changing body position.
Installation 9/16-18 Connections
Installation requires matching the 9/16-18 right-hand and left-hand inlet connections to the regulator and hose set, then securing a compatible Victor 1 Series cutting tip. A common issue is attempting to use the torch for welding, which it does not support, leading to improper flame settings and damaged tips. Another frequent mistake is fitting an incorrect tip series, which causes unstable cuts and excessive gas consumption. Always verify the tip chart for the material thickness before lighting the torch.
Highlights
- Cuts up to 8 in with Victor 1 Series tips
- 180-degree head angle improves access in tight joints
- 21 in length gives extended reach for heavy cuts
- Compatible with oxygen and all fuel gases using proper tip
- 9/16-18 RH and LH inlet connections fit standard regulators
Specifications
| Brand | VICTOR |
|---|---|
| Type | Welding Supplies |
Questions about this item
How much heat does the 180-degree head produce during a full-day cutting job?
The torch head is angled at 180 degrees and cuts steel up to 8 in thick; sustained heat output depends on the fuel gas, tip size and regulator settings you choose.
Which regulators and hoses must I already have to connect the 9/16-18 inlets?
You need oxygen and fuel-gas regulators with 9/16-18 RH and LH outlet fittings plus matching hoses; the torch inlets are 9/16-18 RH for oxygen and 9/16-18 LH for fuel.
Will the Victor 1 Series tips I already own fit this ST2600FC series torch?
Yes, the torch uses Victor 1 Series cutting tips, so existing 1 Series tips in your kit will thread directly onto the head.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
