Victor
Victor 0384-2088 Cutting Outfit 1-1/2" Gauge
Complete oxy-fuel cutting outfit with 90-degree head, 1-1/2 inch gauges and Series 1 tips for natural gas or propane
- Complete cutting outfit with torch handle, regulator and attachment
- 90-degree head angle improves access in tight workspaces
- Compatible with natural gas and propane fuel sources
- Single-stage regulator delivers 150 PSI outlet pressure
- CGA-540 and CGA-510 inlet connections fit standard gas cylinders
Journeyman Select EDGE 2.0 cutting outfit
The Victor 0384-2088 is a complete oxy-fuel cutting outfit built around the Journeyman Select EDGE 2.0 platform. It includes a CA2460+ cutting attachment, a 315FC+ torch handle, and two single-stage ESS42 regulators for oxygen and fuel gas. The kit ships new and carries a California Proposition 65 notice for chemical exposure.
Suited for natural-gas or propane cutting
This outfit is configured for natural gas or propane service with CGA-510 and CGA-540 inlet connections. It accepts 1 Series cutting tips and includes an 8-MFA heating head for pre-heat work. Buyers who need acetylene compatibility or a different regulator inlet standard should select another kit.
1-1/2 inch gauge scale for pressure reading
The regulators feature a 1-1/2 inch gauge face that displays delivery pressure up to 150 on the outlet side. The 90-degree head angle on the cutting attachment sets the torch geometry for standard cutting positions. This gauge size is the primary specification that confirms the outfit matches the required pressure-reading format.
Highlights
- Complete cutting outfit with torch handle, regulator and attachment
- 90-degree head angle improves access in tight workspaces
- Compatible with natural gas and propane fuel sources
- Single-stage regulator delivers 150 PSI outlet pressure
- CGA-540 and CGA-510 inlet connections fit standard gas cylinders
Specifications
| Brand | VICTOR |
|---|
Questions about this item
What gas cylinders and connections must I already have to use the Victor 0384-2088 outfit?
You need an oxygen cylinder with a CGA-540 inlet and a fuel-gas cylinder with a CGA-510 inlet; the regulators connect to 9/16 in.-18 RH and LH outlets respectively.
Will the CA2460+ cutting attachment and 315FC+ torch handle work with my existing Victor 1-Series tips?
Yes, the outfit uses 1-Series cutting tips, so your current Victor 1-Series tips fit the CA2460+ attachment directly.
How can I verify the regulators are delivering the correct pressure after installation?
Check the gauge faces — each regulator is a single-stage ESS42-150 model rated to 150 psi, so the needle should read your set pressure up to that limit.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
