VEVOR
VEVOR Rotary Welding Positioner 10KG 8.1 Inch 3-Jaw Chuck 1-12 RPM 20W
A 20 W motor turns an 8.1 inch three-jaw chuck at 1-12 rpm with a 0-90° tilt table for precise welding positioning
- TypeOther Appliances
- Stable low-speed rotation from a 20W motor running at 1-12 RPM
- Handles up to 10kg horizontal load for secure workpiece support
- 0-90° tiltable table locks at any angle with self-locking worm gear
- 1 inch 3-jaw chuck grips 2-58mm diameters for precise alignment
- Compact 12.6 x 10.6 x 11.1 inch frame weighs only 10.6kg for portability
Rotary welding positioner with 3-jaw chuck
This VEVOR rotary welding positioner provides controlled rotation at 1-12 rpm via a 20 W motor. The 205 mm three-jaw chuck clamps workpieces from 2-58 mm and supports diameters of 22-50 mm. A tiltable worktable locks at any angle from 0-90° using a butterfly bolt and self-locking worm gear.
Suited for light fabrication and bench welding
The unit handles up to 10 kg in horizontal orientation or 5 kg vertically, making it practical for small pipe, bracket and fixture work. Builders needing higher load capacity, faster rotation speeds or a larger chuck diameter should look at heavier-duty positioning equipment instead.
Check bench space and power before ordering
The positioner measures 319 x 270 x 282 mm and weighs 10.6 kg, so confirm your work surface can accommodate the footprint and mass. Ensure a compatible mains supply for the 20 W motor and verify that the included foot pedal and chuck wrenches meet your workflow needs.
Highlights
- Stable low-speed rotation from a 20W motor running at 1-12 RPM
- Handles up to 10kg horizontal load for secure workpiece support
- 0-90° tiltable table locks at any angle with self-locking worm gear
- 1 inch 3-jaw chuck grips 2-58mm diameters for precise alignment
- Compact 12.6 x 10.6 x 11.1 inch frame weighs only 10.6kg for portability
Specifications
| Type | Other Appliances |
|---|
Questions about this item
Does the positioner include the power cord and foot pedal I need to run it?
Yes, the package ships with a power cord, a foot pedal, two chuck wrenches and a user manual so you can operate it straight away.
Will the 205 mm three-jaw chuck hold the 50 mm shaft I already use?
The chuck's supporting range is 22–50 mm, so a 50 mm shaft fits at the upper limit of the holding range.
How can I confirm the turntable is rotating at the speed I set?
Watch the table rotate smoothly at the selected 1–12 rpm setting and listen for the 20 W motor running quietly without vibration.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
