We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver aluminium pneumatic staple gun, compact angled body, 1/4 NPT inlet, safety goggles and wrenches included

VEVOR

VEVOR 7116A Pneumatic Staple Gun 22 Gauge 71 Series 3/8" Crown 5/32-5/8" 70-110 PSI

SKU CH-5GXA-FQF4K

A 22-gauge pneumatic stapler firing 71-series fine-wire staples from 5/32 to 5/8 inch at 70-110 PSI with a 180-staple magazine

  • TypeOther Appliances
  • Width3.15
  • Compatible with 71 series 22 gauge staples 5/32"-5/8" length
  • Magazine holds 180 staples for fewer reload interruptions
  • Sequential firing mode prevents accidental discharge
  • Aluminium alloy body weighs 2.2 lbs for easy handling
  • Operates at 70-110 PSI via 1/4" NPT air inlet

22-Gauge Pneumatic Stapler for Fine Wire Staples

The VEVOR 7116A drives 71 series fine wire staples with a 3/8-inch crown and lengths from 5/32 to 5/8 inch. It is built for upholstery, woodworking and general DIY tasks where a lightweight air tool is preferred.

Operates at 70-110 PSI with 1/4-inch NPT inlet

The tool runs on standard shop air within the stated pressure range and connects via a 1/4-inch NPT fitting. Sequential firing mode prevents accidental discharge, contributing to controlled operation and reduced air consumption during normal use.

Aluminium alloy body weighs 2.2 lbs

The aluminium alloy construction keeps the net weight at 2.2 lbs while the magazine holds up to 180 pieces of 71 series staples, minimising reload interruptions. A 1/4-inch NPT air inlet and included M4 and M5 wrenches simplify hose connection and routine maintenance.

Highlights

  • Compatible with 71 series 22 gauge staples 5/32"-5/8" length
  • Magazine holds 180 staples for fewer reload interruptions
  • Sequential firing mode prevents accidental discharge
  • Aluminium alloy body weighs 2.2 lbs for easy handling
  • Operates at 70-110 PSI via 1/4" NPT air inlet

Specifications

TypeOther Appliances
Width3.15

Questions about this item

How do I connect the 1/4" NPT air inlet to my compressor, and what step do people often miss?

Attach a 1/4" NPT quick-connect fitting to the gun's air inlet, then connect your air hose. The step many miss is setting the regulator to 70-110 PSI before pulling the trigger; running outside that range causes misfires or seal damage.

Which wear parts will need replacement after extended use, and how often?

The driver blade, bumper, and O-ring seals are the typical wear items. With clean, lubricated air at 70-110 PSI they last thousands of cycles; inspect the bumper for cracking and the driver tip for deformation every few months of daily use.

What is the first limitation I will hit during a long upholstery session?

The 180-staple magazine capacity is the first hard stop — you must pause to reload. Heat buildup in the aluminum alloy body is minimal at 70-110 PSI, so magazine refills, not thermal limits, dictate the work rhythm.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.