VEVOR
VEVOR 5HP SPL 230V 17.6A 56 Frame 3450RPM 5/8" Shaft Air Compressor Motor
Delivers 5 HP at 3450 RPM on a 56-frame, 5/8-inch keyed shaft with reversible rotation for 230 V single-phase compressors
- 5HP SPL power drives demanding air compressors
- 3450 RPM single-phase speed at 230V 60Hz
- 56 frame with 5/8" keyed shaft fits standard mounts
- Reversible CW/CCW rotation simplifies wiring installation
- Open drip-proof steel enclosure protects motor in clean dry environments
5 HP SPL 230 V air compressor motor
This 5 HP SPL single-phase motor runs at 3450 RPM on 230 V 60 Hz power and draws 17.6 A at full load. It is built as a direct replacement for stationary air compressors that require a 56-frame footprint and a 5/8-inch keyed shaft.
56 frame ODP steel enclosure
The open drip-proof steel housing protects the windings in clean, dry workshops while allowing fast heat dissipation. A 5/8-inch keyed shaft measuring 1.88 inches long with a 0.188-inch keyway fits standard compressor pulleys, and the reversible design ships set for CCW rotation but can be rewired for CW operation.
45 amp breaker requirement and thermal behaviour
Continuous duty at 1.0 service factor means the motor runs at rated load without overload margin, so a 45 amp circuit breaker is specified for branch-circuit protection. The ODP enclosure relies on ambient airflow for cooling, so dusty or wet locations will reduce service life and increase operating temperature.
Highlights
- 5HP SPL power drives demanding air compressors
- 3450 RPM single-phase speed at 230V 60Hz
- 56 frame with 5/8" keyed shaft fits standard mounts
- Reversible CW/CCW rotation simplifies wiring installation
- Open drip-proof steel enclosure protects motor in clean dry environments
Specifications
No published specifications for this item yet.
Questions about this item
What voltage and phase does the 56-frame motor require, and what current does it draw at full load?
The motor runs on 230 V single-phase 60 Hz power and draws 17.6 A at full load.
What are the shaft diameter, keyway size and usable shaft length for the 56-frame motor?
It has a 5/8" keyed shaft, 0.188" keyway and 1.88" shaft length.
How do you reverse the motor from its factory CCW setting to CW rotation?
Swap the two main winding leads inside the terminal box; the motor is reversible for CW/CCW operation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
