VEVOR
VEVOR 1.5HP Electric Motor 1725 RPM AC 115V/230V 56C Frame 5/8" Keyed Shaft CW/CCW
Single-phase AC motor delivers 1.5 HP at 1725 RPM on dual 115V/230V supply with reversible rotation and overload protection
- TypeOther Appliances
- Width11.02
- 5HP motor delivers 1725 RPM for demanding pump and compressor tasks
- Dual 115V/230V input with 15.0/7.5A draw fits standard shop wiring
- Reversible CW/CCW rotation simplifies installation across multiple equipment types
- 56C frame with 5/8" keyed shaft and 0.188" keyway matches common mounting patterns
- CSA-tested rolled steel housing and manual-reset overload protection extend service life
Motor basics and fit
The VEVOR 1.5 HP single-phase AC motor runs at 1725 RPM on 115 V or 230 V at 60 Hz. It uses a 56C frame with a 5/8 inch keyed shaft and offers reversible CW/CCW rotation for flexible mounting.
Capacity and headroom
Rated output is 1.5 HP with a 1.15 service factor, drawing 15.0 A at 115 V or 7.5 A at 230 V under full load. The design suits water pumps, agricultural machinery and general equipment but will not serve applications needing three-phase power or higher horsepower.
Thermals noise and power
A rolled steel shell and manual-reset overload protection help manage heat during continuous duty. Single-phase operation at 1725 RPM keeps acoustic output moderate, while the 1.15 service factor provides thermal headroom for sustained loads without tripping the protector.
Highlights
- 5HP motor delivers 1725 RPM for demanding pump and compressor tasks
- Dual 115V/230V input with 15.0/7.5A draw fits standard shop wiring
- Reversible CW/CCW rotation simplifies installation across multiple equipment types
- 56C frame with 5/8" keyed shaft and 0.188" keyway matches common mounting patterns
- CSA-tested rolled steel housing and manual-reset overload protection extend service life
Specifications
| Type | Other Appliances |
|---|---|
| Width | 11.02 |
Questions about this item
Will the 56C frame and 5/8" keyed shaft match the mounting pattern on my existing pump?
The motor uses a standard 56C frame with a 5/8" keyed shaft that is 1.88" long and has a 0.188" keyway, so it fits common 56C mounting patterns.
How can I verify the motor is running correctly after wiring it for 115V?
At 115V the nameplate current is 15.0A and the shaft should turn at 1725 RPM under load; the overload protector will trip if current exceeds the 1.15 service factor.
Does the box include a capacitor, mounting bolts or a power cord?
The package contains only the motor and a user manual; capacitors, mounting hardware and wiring must be sourced separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
