Venstar
Venstar Hotel Guestat Thermostat T0051FS
Programmable thermostat links to door or motion sensors to cut energy costs while auto-changeover manages heating and cooling stages
- TypeProgrammable Thermostats
- Cuts energy costs by linking to door or motion sensors
- Programmable with auto-changeover for automatic heating and cooling switching
- FlatStat design installs flush with the wall for a clean look
- Works with 3-speed fan equipment and most HVAC systems
- Compatible with optional LX-24 occupancy sensor powered via 24 VDC supply
Hotel energy thermostat
The Venstar T0051FS is a programmable thermostat built for hotel rooms. It links to a door or motion sensor so heating and cooling run only when the room is occupied. The flat profile installs flush with the wall for a clean finish. Property managers use it to cut energy waste without sacrificing guest comfort.
Occupancy-sensor integration
The single specification that decides fit is the 24 VDC sensor interface. The thermostat supplies power to an optional passive infrared occupancy sensor such as the LX-24 through a DCP-1.5-W supply. If the project does not use a 24 V sensor loop this model adds cost without benefit.
System capacity and limits
It controls 1 or 2 stage electric cooling with 2 stage gas heating, heat-pump, electric or hydronic heat and 3-speed fan equipment. The 1.5 A regulated supply powers the sensor circuit. Buildings needing more than two heating stages or a different control voltage will exceed what this thermostat can handle.
Highlights
- Cuts energy costs by linking to door or motion sensors
- Programmable with auto-changeover for automatic heating and cooling switching
- FlatStat design installs flush with the wall for a clean look
- Works with 3-speed fan equipment and most HVAC systems
- Compatible with optional LX-24 occupancy sensor powered via 24 VDC supply
Specifications
| Type | Programmable Thermostats |
|---|
Questions about this item
How does the programmable scheduling actually reduce energy costs in a hotel room?
The thermostat links to a door or motion sensor so it only runs heating or cooling when the room is occupied, cutting waste during vacant periods.
What does the 24 VAC supply from the thermostat actually power in practice?
It feeds the optional DCP-1.5-W power supply which converts it to 24 VDC for the LX-24 occupancy sensor, enabling presence detection without separate wiring.
What wall preparation is needed for the flush-mount design?
The unit installs flat against the wall surface, so a standard electrical box opening is sufficient; no protruding housing or extra depth is required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
