VANGUARD
VANGUARD VEO 3 GO 235AB 23mm 5-Section Aluminum Travel Tripod 8.8 lbs
A compact five-section aluminum travel tripod folds to 13 inches and weighs 2.7 lbs while supporting up to 8.8 lbs of gear
- Supports cameras up to 8.8 lbs for secure shooting
- Folds to 13 inches for easy travel packing
- Weighs only 2.7 lbs for lightweight portability
- Extends to 53.5 inches or drops to 7.9 inches
- One leg converts to monopod for versatile use
Travel Tripod for Mirrorless and DSLR Kits
The Vanguard VEO 3 GO 235AB is a 5-section aluminum travel tripod with an included T-50 ball head. It supports mirrorless and DSLR camera kits as well as smartphones up to 8.8 lbs. One leg converts into a monopod, vlogging stick or selfie stick for extra flexibility. The Arca-Swiss-compatible head provides smooth, precise adjustments with an ergonomic locking knob.
Lightweight Aluminum Build for Portable Use
Weighing 2.7 lbs, the tripod folds down to 13 inches for easy packing in luggage. The 23 mm diameter legs use twist locks for rapid deployment in seconds. Maximum extended height reaches 53.5 inches while the minimum height drops to 7.9 inches for low-angle compositions. The sturdy aluminum construction keeps the camera secure across varied shooting conditions.
8.8 lb Load Capacity Determines Compatibility
The single specification that decides fit is the maximum load capacity of 8.8 lbs. Heavier cinema rigs or large telephoto lens combinations that exceed this limit will not be supported safely. Buyers needing more capacity should consider a higher-rated support system. The 5-section leg design and monopod conversion do not change this limit.
Highlights
- Supports cameras up to 8.8 lbs for secure shooting
- Folds to 13 inches for easy travel packing
- Weighs only 2.7 lbs for lightweight portability
- Extends to 53.5 inches or drops to 7.9 inches
- One leg converts to monopod for versatile use
Specifications
No published specifications for this item yet.
Questions about this item
How do I attach the camera to the T-50 ball head, and what step is often missed?
Slide the Arca-Swiss plate into the clamp, tighten the locking knob fully, then engage the safety stop so the plate cannot slide out if the knob loosens.
Which parts of the VEO 3 GO 235AB will need maintenance or replacement after heavy use?
The twist-lock collars on the 23 mm, 5-section legs can collect grit; clean and lightly grease the threads periodically, and replace the rubber foot pads when they wear smooth.
What is the first limit I will hit when shooting long exposures at the 53.5 inch extended height with an 8.8 lb load?
The 5-section leg design introduces more joint flex than fewer sections, so vibration from wind or shutter shock becomes the limiting factor before the 8.8 lb capacity is reached.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



