Value Brand
Value Brand Straight 3/4 in Hose I.D. 1/2"-14 Thread Brass
Straight brass push-on fitting connects 3/4 in hose to 1/2"-14 NPT thread at 250 psi
- Straight-through flow with 3/4 in hose barb and 1/2 in NPT thread
- Brass H59 construction resists corrosion and handles 250 psi service pressure
- Reusable push-on design installs without clamps or special tools
- Hex 55/64 in allows positive wrench grip for leak-free tightening
- Prop 65 listed for cancer and reproductive-hazard chemicals
Straight brass hose fitting
The Value Brand straight fitting connects a three-quarter inch hose barb to a half-inch male NPT thread. Brass construction resists corrosion in compressed-air lines. The reusable design allows disassembly without damaging the hose. Rated for 250 psi service.
For air-tool supply lines
Suits installers joining large-bore hose to half-inch ports on compressors, regulators or manifolds. Not for hydraulic circuits exceeding the pressure rating. Buyers needing a swivel elbow, a different thread size or a stainless body should look elsewhere.
Push-on installation
Lubricate the barb, push the hose fully onto the fitting and secure with a clamp. The fifty-five sixty-fourths hex provides a positive wrench grip. Leaks usually come from an undersized clamp or a hose cut that is not square.
Highlights
- Straight-through flow with 3/4 in hose barb and 1/2 in NPT thread
- Brass H59 construction resists corrosion and handles 250 psi service pressure
- Reusable push-on design installs without clamps or special tools
- Hex 55/64 in allows positive wrench grip for leak-free tightening
- Prop 65 listed for cancer and reproductive-hazard chemicals
Specifications
| Brand | ZORO SELECT |
|---|
Questions about this item
What size hose do I need to fit the 3/4 in barb on this fitting?
You need a hose with a 3/4 in inner diameter to match the barb size on this straight fitting.
Will the 1/2"-14 NPT thread connect to the port on my existing compressor or tool?
The male NPT end uses a standard 1/2"-14 thread pitch, compatible with any female port cut to that same specification.
How can I confirm the 250 psi brass fitting is holding pressure after I install it?
Pressurise the line to your working pressure, then brush soapy water over the joints; no bubbles mean the seal is sound.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
