Value Brand
Value Brand Double-Bolt Hose Clamp 1 in zinc-plated steel
Zinc-plated steel double-bolt clamp secures compressor hoses and pneumatic couplings with 10 mm hex hardware
- Zinc-plated steel resists corrosion on compressor hoses
- Double-bolt design secures pneumatic couplings up to 2 19/64 in ID
- 276 in band thickness withstands 27 ft-lb install torque
- 10 mm hex size allows standard tool installation
- 1 in band width distributes clamping force evenly
Zoro Select Double-Bolt Hose Clamp
This Zoro Select double-bolt hose clamp is built from zinc-plated steel for corrosion resistance. The band measures 1 in wide and 0.276 in thick, with a screw and housing that share the same plated finish. It is designed for compressor hoses and low-pressure pneumatic couplings.
Suits maintenance crews and shop technicians
The clamp fits inside diameters from 2 7/64 in to 2 19/64 in and installs with a 10 mm hex at 27 ft-lb of torque. Buyers who need a worm-gear style or a different diameter range should look at alternative clamp types.
Mounts directly onto hose assemblies
The double-bolt design distributes clamping force evenly around the connection without requiring special tools beyond a standard 10 mm driver. Zinc plating on all steel components helps the hardware withstand shop fluids and humidity over repeated service cycles.
Highlights
- Zinc-plated steel resists corrosion on compressor hoses
- Double-bolt design secures pneumatic couplings up to 2 19/64 in ID
- 276 in band thickness withstands 27 ft-lb install torque
- 10 mm hex size allows standard tool installation
- 1 in band width distributes clamping force evenly
Specifications
| Brand | Zoro Select |
|---|
Questions about this item
What hose outside diameter do I need so the 1 in zinc-plated band with a 2 19/64 in maximum inside diameter can seal properly?
Choose a hose whose outside diameter fits between the 2 7/64 in minimum and 2 19/64 in maximum inside diameters so the clamp can tighten fully without bottoming out.
Will the 10 mm hex heads on these double-bolt clamps clear the fittings on my older compressor hoses?
The 10 mm hex size is standard for many pneumatic couplings, so the clamp should engage without interference on most legacy hose assemblies.
How do I verify the clamp is tightened to the specified 27 ft-lb install torque after setup?
Use a calibrated torque wrench on each 10 mm hex bolt and confirm both reach 27 ft-lb; the band should sit flat with no visible gap between the housing and hose.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
