Value Brand
Value Brand Anchor Ring Surface PK12
Pack of twelve zinc-plated steel D-ring anchors with a 400 lb working load limit for weld-on mounting
- Steel construction resists corrosion with zinc-plated finish
- 400 lb working load limit secures heavy cargo safely
- Pivot anchor movement adjusts to shifting load angles
- Weld-on mounting creates permanent attachment points
- Pack of 12 rings covers multiple tie-down locations
Anchor Ring Surface Mount 12 Pack
This pack contains twelve zinc-plated steel anchor rings designed for permanent weld-on installation. Each ring provides a pivoting D-ring attachment point with a 400 lb working load limit. The silver finish resists corrosion in general service environments. They suit workshops and fabrication projects that need multiple fixed tie-down points.
Fabrication Shops Adding Fixed Tie-Downs
The rings are intended for installers who can weld directly to steel structures and require a low-profile recessed D-ring that pivots under load. Buyers who need bolt-on hardware, removable anchors or a higher working load limit should consider alternative mounting styles. The weld-only design also makes these unsuitable for temporary or rental applications.
400 lb Working Load Limit
This capacity figure determines whether the ring can handle the intended load safely. Verify that the expected tension never exceeds 400 lb before specifying these anchors. The limit applies to the ring itself and assumes a proper weld to a suitable base material.
Highlights
- Steel construction resists corrosion with zinc-plated finish
- 400 lb working load limit secures heavy cargo safely
- Pivot anchor movement adjusts to shifting load angles
- Weld-on mounting creates permanent attachment points
- Pack of 12 rings covers multiple tie-down locations
Specifications
| Brand | Zoro Select |
|---|
Questions about this item
Does the 4 in overall width of the anchor ring suit my mounting surface?
The ring measures 4 in overall width and 4 in overall length, so check that your surface can accommodate that footprint before welding it in place.
What preparation is required before welding the anchor ring, and what step is often missed?
Clean the steel base to bare metal, position the ring for the pivot movement, then weld continuously around the base; the step often missed is achieving full penetration on all sides for the 400 lb working load limit.
How will the zinc-plated finish hold up, and when should the ring be replaced?
The zinc plating resists corrosion, but inspect the 1/4 in thick ring regularly for wear, deformation or cracking; replace it immediately if the inner diameter shows elongation or the steel shows deep pitting.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
