Value Brand
Value Brand 6AFR2 Brass Hose Barb 1/2 in x 1/4 in 90° Elbow 300 psi
Brass 90° elbow hose barb connects 1/2 in hose to 1/4 in NPT at 300 psi
- Durable brass construction resists corrosion
- 90° elbow redirects hose runs in tight spaces
- 1/2 in barb to 1/4 in NPT connects hose to pipe threads
- Rated for 300 psi working pressure in pneumatic or water systems
- California Proposition 65 warning applies to this product
Brass hose barb for low-pressure pneumatics
The Value Brand 6AFR2 is a brass barbed fitting with a 90 degree elbow that joins 1/2 inch hose to a 1/4 inch male NPT thread. It is rated for 300 psi maximum operating pressure and intended for one-time installation in air or water lines. The fitting contains chemicals listed under California Proposition 65 for cancer and reproductive harm.
Suited for simple pneumatic or water routing
This elbow suits technicians who need a permanent, rigid direction change in low-pressure systems without a shut-off valve. It is not for builders who need reusable connections, higher pressure ratings, different thread sizes, or integrated flow control. The single-use design also makes it unsuitable for applications requiring frequent disassembly.
Fits into hose assemblies with NPT ports
The barbed end pushes into 1/2 inch inner-diameter hose while the 1/4 inch male NPT threads into a matching female port, requiring thread sealant for a leak-free joint. The 90 degree bend re-routes flow in tight spaces and eliminates the need for a separate elbow and straight adapter. No additional components are included.
Highlights
- Durable brass construction resists corrosion
- 90° elbow redirects hose runs in tight spaces
- 1/2 in barb to 1/4 in NPT connects hose to pipe threads
- Rated for 300 psi working pressure in pneumatic or water systems
- California Proposition 65 warning applies to this product
Specifications
| Brand | ZORO SELECT |
|---|
Questions about this item
What size hose and thread does the 1/2 in x 1/4 in 90° elbow fit?
The barb accepts 1/2 inch ID hose and the male thread is 1/4 inch NPT.
Will the brass elbow handle the pressure from my older 300 psi compressor?
Yes, the fitting is rated for a maximum operating pressure of 300 psi.
How can I confirm the joint is sealed after I clamp the hose on?
Pressurise the line to working pressure and check for leaks at the barb and threads.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
