We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Galvanized carbon steel pipe nipple, threaded both ends, silver-grey finish

Value Brand

Value Brand 566-240GR 1-1/4" MNPT x 2 ft Galvanized Carbon Steel Pipe Nipple

SKU CH-01Z7-QMVZD

Threaded 1-1/4" galvanized carbon steel nipple, 2 ft long, schedule 40, rated 1145 psi at 650 °F

  • Galvanized coating resists corrosion on carbon steel pipe
  • Schedule 40 wall thickness 0.14 in handles 1145 psi at 650 Degrees F
  • Electric resistance welded seam meets ASTM A-53 and A-733 standards
  • 38 in inside diameter and 1.66 in outside diameter suit 1-1/4 in nominal size
  • MNPT threads on both ends allow direct threaded connections

1-1/4" Galvanized Pipe Nipple

This 2 ft galvanized carbon steel nipple provides a threaded connection for Schedule 40 piping systems. The MNPT threads on both ends allow direct assembly with standard fittings in water, gas or air lines.

Electric Resistance Weld Construction

The pipe is fabricated with an electric resistance weld and hot-dip galvanized for corrosion resistance. With a 1.66 in outside diameter and 0.14 in wall thickness, it meets ASTM A-53 and ASTM A-733 standards for structural integrity.

Replaces Plain-End or Lower-Rated Pipe

Use this nipple when a threaded, pressure-rated joint is required up to 1145 psi at 650°F. It is not suited for systems needing grooved, flanged or compression connections, or for pressures exceeding the Schedule 40 rating.

Highlights

  • Galvanized coating resists corrosion on carbon steel pipe
  • Schedule 40 wall thickness 0.14 in handles 1145 psi at 650 Degrees F
  • Electric resistance welded seam meets ASTM A-53 and A-733 standards
  • 38 in inside diameter and 1.66 in outside diameter suit 1-1/4 in nominal size
  • MNPT threads on both ends allow direct threaded connections

Specifications

BrandZORO SELECT

Questions about this item

What pressure does the Schedule 40 rating cap at 650 Degrees F?

The pipe nipple is rated for a maximum of 1145 psi at 650 Degrees F under the Schedule 40 designation.

What are the outside diameter and wall thickness for 1-1/4 in nominal pipe?

The outside diameter is 1.66 in and the wall thickness is .14 in for this nominal size.

How do you seal the MNPT threads without cracking the galvanized fitting?

Apply PTFE tape or pipe dope to the male threads only, then tighten one to two turns past hand-tight; over-torquing splits the galvanized coating.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.