Value Brand
Value Brand 2 in x 50 ft Water Discharge Hose 125 PSI White
A 50 ft white water discharge hose with 2 in aluminium fittings, 125 psi working pressure and 375 psi burst rating
- Delivers water at 125 psi working pressure for reliable flow
- Withstands 375 psi burst pressure for a 3:1 safety margin
- Operates from -22 to 180 °F for year-round use
- 50 ft length reduces couplings on long runs
- Aluminium fittings at both ends for quick, secure connections
2-inch 50-foot water discharge hose
This white rubber hose has a 2-inch inside diameter and a 50-foot length. It is built with an SBR tube, a polyester cover and a braided fibre reinforcement. Aluminium fittings on both ends are sized to match the 2-inch bore. The assembly is rated for a maximum working pressure of 125 psi at 70 degrees Fahrenheit.
Replaces worn or undersized discharge lines
A hose with a 375 psi burst pressure and a 3:1 safety factor upgrades older lines that show cracking, hardening or reduced flow. The step up is worthwhile when the current hose cannot hold 125 psi working pressure or when its temperature rating falls short of the minus 22 to 180 degrees Fahrenheit range required by the application.
Suits water transfer, dewatering and irrigation
Contractors and facility crews moving large volumes of water will find the 2-inch bore and 50-foot reach practical. Buyers who need a higher working pressure, a different inside diameter or a hose rated for chemicals or petroleum products should look at other constructions.
Highlights
- Delivers water at 125 psi working pressure for reliable flow
- Withstands 375 psi burst pressure for a 3:1 safety margin
- Operates from -22 to 180 °F for year-round use
- 50 ft length reduces couplings on long runs
- Aluminium fittings at both ends for quick, secure connections
Specifications
| Brand | ZORO SELECT |
|---|
Questions about this item
What are the inside and outside diameters of the 50 ft hose?
The hose has a 2 in inside diameter and a 2 3/4 in outside diameter, so any coupling or clamp must match those dimensions.
How do the aluminium fittings attach to the braid-reinforced SBR tube, and what step is often missed?
The 2 in aluminium fittings on each end are crimped onto the fibre-braid reinforced SBR tube; the step often missed is fully seating the hose before tightening the clamp to avoid leaks at 125 psi.
When should the hose be replaced based on its pressure rating and temperature limits?
Replace the hose if it shows cover cracks, tube softening, or fitting corrosion after repeated exposure to the 375 psi burst rating or temperatures beyond the -22 to 180 °F range.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
