We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Galvanized steel pipe nipple, 2 inch MNPT by 3 inch TBE, Schedule 40

Value Brand

Value Brand 2 in MNPT x 3 in TBE Galvanized Steel Pipe Nipple Sch 40

SKU CH-9BKH-5FRYB

Galvanized steel pipe nipple with 2 in MNPT and 3 in TBE ends for Schedule 40 systems rated to 300 psi at 150 Degrees F

  • Schedule 40 steel handles 300 psi at 150 °F
  • Galvanized coating resists corrosion in air, gas and potable water
  • Electric resistance weld ensures consistent joint strength
  • 2 in MNPT threads mate with standard Schedule 40 fittings
  • 3 in overall length suits tight piping runs

2 in MNPT x 3 in TBE Galvanized Nipple

This galvanized steel pipe nipple connects male NPT threads to a TBE end for air, gas or potable water lines. It is manufactured to Schedule 40 dimensions with an electric resistance weld for consistent wall thickness. The fitting is globally sourced and carries a corrosion-resistant coating for extended service life.

Schedule 40 Build and Threaded Ends

The nipple withstands a maximum operating pressure of 300 psi at 150 degrees F and a maximum steam pressure of 150 psi at 350 degrees F. Its 2 3/8 in outside diameter matches Schedule 40 pipe standards, while the MNPT and TBE threads allow direct assembly without additional adapters. The galvanized finish protects the steel substrate in damp or outdoor installations.

Verify Thread Type and Pressure Rating

Confirm that your existing piping uses compatible NPT threads and that system pressures remain within the 300 psi and 150 psi limits stated above. The product contains a chemical known to the State of California to cause cancer and reproductive harm, so review local handling requirements before installation. Ensure the 3 in overall length fits the available space between fittings.

Highlights

  • Schedule 40 steel handles 300 psi at 150 °F
  • Galvanized coating resists corrosion in air, gas and potable water
  • Electric resistance weld ensures consistent joint strength
  • 2 in MNPT threads mate with standard Schedule 40 fittings
  • 3 in overall length suits tight piping runs

Specifications

BrandZORO SELECT

Questions about this item

What does the Schedule 40 rating mean for the pressure this 2 in MNPT x 3 in galvanized steel nipple can handle?

The Schedule 40 rating allows a maximum operating pressure of 300 psi at 150 degrees F and a maximum steam pressure of 150 psi at 350 degrees F.

What are the exact thread size and overall length needed to fit this nipple into an existing 2 inch galvanized steel piping run?

It has a 2 inch nominal pipe size with a 2 3/8 inch outside diameter and a 3 inch overall length with male NPT threads on one end.

How do I correctly install this threaded nipple so the joint seals without damaging the galvanized coating?

Apply pipe thread sealant or tape to the male NPT threads, hand-tighten into the female fitting, then wrench-tighten one to two turns while avoiding over-torquing the galvanized surface.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.