Value Brand
Value Brand 1-1/2" x 50 ft Rubber Water Discharge Hose 125 PSI
50 ft rubber discharge hose rated 125 psi with 375 psi burst strength and aluminum fittings
- 1-1/2 in diameter moves high volumes of water
- 50 ft length reaches distant discharge points
- 125 psi working pressure handles demanding pump output
- 375 psi burst rating provides 3:1 safety margin
- 22 to 180 °F range suits cold and hot conditions
1-1/2" x 50 ft Rubber Water Discharge Hose
This 50-foot discharge hose has a 1-1/2 inch inside diameter and a 1-3/4 inch outside diameter. The tube uses SBR rubber with a white polyester braided cover. Aluminium fittings on both ends match the 1-1/2 inch bore. It is rated for a maximum working pressure of 125 psi at 70 degrees F.
Upgrade from lower-pressure or shorter hoses
A 375 psi burst pressure and a 3:1 safety factor provide a reliable step up from hoses rated below 125 psi working pressure. The 50-foot length reduces the need for multiple couplings on longer runs. The temperature range of -22 to 180 degrees F suits jobs that exceed the limits of standard PVC discharge hose.
Suits water transfer, irrigation and dewatering
The SBR tube and polyester cover resist abrasion and weathering in outdoor service. Aluminium fittings are lightweight and corrosion resistant for frequent coupling. Buyers needing oil resistance, chemical compatibility or higher working pressures should select a hose specified for those media.
Highlights
- 1-1/2 in diameter moves high volumes of water
- 50 ft length reaches distant discharge points
- 125 psi working pressure handles demanding pump output
- 375 psi burst rating provides 3:1 safety margin
- 22 to 180 °F range suits cold and hot conditions
Specifications
| Brand | Zoro Select |
|---|
Questions about this item
What size fittings does the 1-1/2" discharge hose use?
Both ends have 1-1/2 inch aluminum fittings that match the hose inside diameter.
How do I install the hose and what step is often missed?
Thread the aluminum fittings onto the pump and outlet, then tighten with a wrench; the step often missed is checking that the braid reinforcement is not twisted before pressurising.
When should I replace this rubber water discharge hose?
Replace it if the SBR tube or polyester cover shows cracks, soft spots, or leaks, or after the burst pressure of 375 psi has been exceeded.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
