We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Short galvanized steel pipe nipple with threaded ends

Value Brand

Value Brand 1-1/2" MNPT x 3" TBE Galvanized Steel Pipe Nipple Sch 40

SKU CH-6JXY-H1ZN0

Galvanised steel pipe nipple with 1-1/2 inch MNPT threads and 3 inch overall length for Schedule 40 systems

  • Corrosion-resistant galvanized coating extends service life in wet systems
  • Schedule 40 wall handles 300 psi at 150 °F for air and water
  • Electric resistance welded seam provides consistent strength along full length
  • 1-1/2 inch NPT threads connect directly to standard fittings
  • Suitable for potable water, air and gases per listed application

Galvanised Steel Pipe Nipple Schedule 40

This 1-1/2 inch MNPT by TBE nipple is made from welded steel with a galvanised finish for corrosion resistance. It suits air, gas and potable water lines in residential and light commercial plumbing. The Schedule 40 wall meets standard pressure requirements for these services.

Replaces worn or damaged threaded nipples

Swap out a corroded or leaking nipple of the same nominal size and thread type to restore a tight joint without re-piping the whole run. The jump is worth it when the existing fitting shows scale build-up, stripped threads or visible seepage under pressure.

Holds 300 psi at 150 °F and 150 psi steam at 350 °F

Electric resistance welded construction maintains integrity under sustained operating pressure rather than only brief test spikes. Galvanised coating resists long-term exposure to moisture and condensate in continuous service. California Proposition 65 warnings apply.

Highlights

  • Corrosion-resistant galvanized coating extends service life in wet systems
  • Schedule 40 wall handles 300 psi at 150 °F for air and water
  • Electric resistance welded seam provides consistent strength along full length
  • 1-1/2 inch NPT threads connect directly to standard fittings
  • Suitable for potable water, air and gases per listed application

Specifications

BrandZORO SELECT

Questions about this item

What thread size does the 1-1/2" MNPT end need to match?

The male NPT end is sized for 1-1/2 inch nominal pipe threads; it mates with a female NPT fitting of the same nominal size.

How do I seal the threads during installation without causing leaks?

Apply PTFE tape or pipe dope to the male threads only, then tighten to the recommended torque; over-tightening can split the galvanized coating and create a leak path.

When should I plan to replace the nipple due to corrosion or wear?

Inspect annually; replace if white rust, pitting, or thread damage appears, especially in systems running near the 300 psi @ 150 °F water limit or 150 psi @ 350 °F steam limit.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.