We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Galvanized carbon steel pipe nipple, threaded both ends, 2 ft long, 1.9 in outside diameter

Value Brand

Value Brand 1-1/2" MNPT x 2 ft TBE Carbon Steel Pipe Nipple Sch 40

SKU CH-YR2R-VWKRT

Schedule 40 carbon steel pipe nipple with MNPT threads on both ends, 2 ft long, rated to 1064 psi at 650 °F

  • Galvanized carbon steel resists corrosion
  • Schedule 40 wall thickness rated for 1064 psi at 650 °F
  • Threaded both ends for direct MNPT connections
  • Electric resistance welded seam meets ASTM A-53 and A-733
  • 61 in bore with 1.9 in outside diameter for standard fittings

1-1/2" Schedule 40 carbon steel nipple

This 2 ft galvanized nipple has male NPT threads on both ends and a 1.61 in inside diameter. It is built to ASTM A-53 and ASTM A-733 standards for general plumbing and fluid transfer. The electric resistance weld construction provides a consistent wall thickness of .145 in. Suitable for installers needing a standard threaded pipe section.

Installation uses standard NPT tooling

Thread sealant or tape on the 1-1/2" MNPT ends creates the seal when tightened to spec. The 1.9 in outside diameter fits common wrenches and pipe vises. Over-tightening can distort threads or crack the galvanized coating, so follow normal NPT engagement practice. The welded seam is pressure rated to 1064 psi at 650 °F.

Verify thread type and pressure rating

Confirm the mating fittings use NPT threads rather than BSPT or other standards to avoid leaks. Check that the system design pressure and temperature stay within the 1064 psi at 650 °F limit. Ensure the 1.61 in bore matches the required flow capacity for the application. The nipple is not intended for potable water without further certification.

Highlights

  • Galvanized carbon steel resists corrosion
  • Schedule 40 wall thickness rated for 1064 psi at 650 °F
  • Threaded both ends for direct MNPT connections
  • Electric resistance welded seam meets ASTM A-53 and A-733
  • 61 in bore with 1.9 in outside diameter for standard fittings

Specifications

BrandZORO SELECT

Questions about this item

How do I confirm the nipple is holding pressure after installation?

Pressurise the system up to 1064 psi at 650 degrees F and check for leaks at the MNPT threads; the galvanized carbon steel construction and electric resistance weld should show no weeping.

What comes in the box and what must I supply?

The box contains the 2 ft Schedule 40 nipple with 1.9 in outside diameter and .145 in wall thickness; you must provide thread sealant or tape and any mating fittings.

Which schedule and length should I choose for my 1-1/2 inch line?

Select the Schedule 40 version with 1.61 in inside diameter and 2 ft overall length when your design calls for ASTM A-53 and WWN 351 compliance at 1064 psi.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.