Value Brand
Value Brand 1-1/2" ID x 50 ft Rubber Water Discharge Hose 125 PSI White
A 50 ft white rubber water discharge hose rated for 125 psi working pressure and 375 psi burst pressure, operating from -22 to 180 degrees F
- Handles high-volume flow with 1-1/2 in. inside diameter
- 50 ft length reaches distant job sites
- 125 psi working pressure suits demanding discharge tasks
- 375 psi burst rating provides 3:1 safety margin
- Operates from -22 °F to 180 °F for year-round use
1-1/2" ID x 50 ft Water Discharge Hose
This rubber hose has a 1-1/2 inch inside diameter and a 50 foot length. It is rated for a maximum working pressure of 125 psi at 70 degrees Fahrenheit. The tube uses SBR material with a polyester cover and braided fiber reinforcement. Both ends come fitted with 1-1/2 inch aluminum and brass couplings.
Check fittings pressure and temperature limits
Verify that your pump or outlet accepts 1-1/2 inch fittings before ordering. The hose bursts at 375 psi with a 3:1 safety factor, so ensure your system pressure stays at or below 125 psi. Confirm the operating temperature remains between -22 and 180 degrees Fahrenheit for safe use. The Proposition 65 warning notes chemicals linked to cancer and reproductive harm.
Suited for general water discharge tasks
This hose fits applications needing a 50 foot reach with 125 psi working pressure and standard 1-1/2 inch connections. Buyers who need a higher pressure rating, a different inside diameter, or a longer continuous length should look at other options. The white polyester cover and SBR tube are designed for water discharge service.
Highlights
- Handles high-volume flow with 1-1/2 in. inside diameter
- 50 ft length reaches distant job sites
- 125 psi working pressure suits demanding discharge tasks
- 375 psi burst rating provides 3:1 safety margin
- Operates from -22 °F to 180 °F for year-round use
Specifications
| Brand | Zoro Select |
|---|
Questions about this item
Does the hose arrive with both fittings attached or do I need to buy couplings separately?
The 50 ft hose ships with a 1-1/2 in aluminum fitting on one end and a 1-1/2 in brass fitting on the other, so no extra couplings are required for standard connections.
Should I choose a different length or diameter for lower pressure loss on long runs?
This model is offered only in a 50 ft length with a 1-1/2 in inside diameter; if your layout needs a shorter run or larger bore you would need a different hose specification.
Will the 125 psi rating hold when the water temperature reaches 180 °F in my system?
The 125 psi maximum working pressure is rated at 70 °F; at higher temperatures the allowable pressure drops, so at 180 °F you must operate below the 125 psi figure.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
