We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
White polyethylene tubing coil 10 ft length

Usa Sealing

Usa Sealing ZUSA-HT-3376 Tubing Polyethylene 1/4" I.D. 3/8" O.D. 10 ft

SKU CH-55V1-VSX1M

White polyethylene tubing for beverage, food and water lines, 10 ft length with 1/4 in inside diameter and 290 psi maximum pressure

  • ColorWhite
  • Food-safe polyethylene for beverage and water lines
  • Shore D 45 hardness resists kinking and cracking
  • 290 psi pressure rating handles demanding supply tasks
  • Withstands 140 °F for hot-water compatibility
  • 10 ft coil cuts to exact lengths needed

Product Identity

The ZORO SELECT ZUSA-HT-3376 is a 10 ft length of white polyethylene tubing with a 1/4 in inside diameter and 3/8 in outside diameter. It is suited for beverage, food and water lines where chemical resistance and a Shore D 45 hardness are required.

Upgrade Context

This tubing replaces softer or unrated lines that cannot handle 290 psi operating pressure or 140 Degrees F continuous temperature. The step up is justified when a system demands documented pressure and temperature limits rather than generic clear hose.

Sustained Load Behaviour

Under continuous pressure the polyethylene wall resists creep and holds its rated 290 psi limit without swelling. The material maintains chemical resistance and dimensional stability at the full 140 Degrees F operating temperature over extended runs.

Highlights

  • Food-safe polyethylene for beverage and water lines
  • Shore D 45 hardness resists kinking and cracking
  • 290 psi pressure rating handles demanding supply tasks
  • Withstands 140 °F for hot-water compatibility
  • 10 ft coil cuts to exact lengths needed

Specifications

ColorWhite
BrandZORO SELECT

Questions about this item

What size barbed fittings match the 1/4" I.D. and 3/8" O.D. of this tubing?

Use barbed fittings sized for 1/4 inch inside diameter; the 3/8 inch outside diameter seats against the barb shoulder for a secure seal.

How do I install this polyethylene tubing onto a barbed fitting without kinking it?

Warm the tubing end in hot water for a few seconds, push it fully over the barb until it contacts the fitting shoulder, then secure with a clamp.

When should I replace this tubing based on its temperature and pressure limits?

Replace if the line regularly exceeds 140 °F or 290 psi, or if the white polyethylene shows cracking, hardening, or permanent deformation.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.