We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Usa Sealing

Usa Sealing ZUSA-HT-2245 NSF Clear PVC Tubing 3/4" ID x 1" 25 ft

SKU CH-JDHX-P1KZF

Clear PVC tubing rated for food, beverage and water use with a 3/4 in inside diameter, 1 in outside diameter, 25 ft length, Shore A 65 hardness and a 15 psi maximum operating pressure at 140 °F

  • ColorClear
  • Clear PVC for beverage, food and water lines
  • NSF listed material meets sanitary standards
  • 15 psi rating handles low-pressure dispensing
  • Withstands 140 °F for hot fluid use
  • 25 ft coil reduces joints in long runs

Clear PVC Tubing for Food-Grade Use

This NSF-certified clear PVC tubing is designed for beverage, dairy, food, and water applications. It suits commercial kitchens, food-processing lines, and potable-water systems that require a transparent, non-jacketed line. The Shore A 65 hardness provides a balance of flexibility and kink resistance for routine fluid transfer.

Replaces Opaque or Non-Rated Lines

Upgrade from tubing that lacks NSF certification or food-grade material approval when compliance and visual flow monitoring are required. The jump is worth it for installations handling dairy or beverages where material purity and a 15 psi pressure rating at 140 Degrees F are specified. It is not for high-pressure hydraulic circuits or applications exceeding the stated temperature and pressure limits.

Practical Limits of 15 psi PVC

The 15 psi maximum operating pressure restricts use to low-pressure gravity feed, suction, or peristaltic pump systems. The 140 Degrees F temperature ceiling excludes steam lines or high-temperature sanitisation cycles. The 25 ft coil length defines the maximum continuous run without fittings, and the 3/4 in inside diameter fixes the flow capacity for the system design.

Highlights

  • Clear PVC for beverage, food and water lines
  • NSF listed material meets sanitary standards
  • 15 psi rating handles low-pressure dispensing
  • Withstands 140 °F for hot fluid use
  • 25 ft coil reduces joints in long runs

Specifications

ColorClear
BrandZORO SELECT

Questions about this item

What size barbed fitting does the 3/4 in ID x 1 in OD PVC tubing accept?

The tubing accepts barbed fittings with a 3/4 in shank; cut square with a sharp cutter, warm the end in hot water until pliable, then push fully onto the barb so the 1 in OD seats against the fitting shoulder.

How do you secure the tubing to a pump head or fitting without kinking the 25 ft coil?

Slide a stainless hose clamp over the warmed tube, push the tube onto the barb until it bottoms out, then tighten the clamp just enough to seal — over-tightening crushes the 65 Shore A wall and causes leaks.

When should the clear PVC tubing be replaced in a peristaltic pump running at 140 °F?

Replace the tubing when the wall turns cloudy, hardens, or shows fine cracks from heat and roller flex — typically after the rated 15 psi / 140 °F service window is exceeded.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.