We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Yellow PVC tubing coil 3/8 inch inside diameter 1/2 inch outside diameter 10 feet length

Usa Sealing

Usa Sealing ZUSA-HT-1224 PVC Tubing Yellow 3/8 in ID 1/2 in OD 10 ft

SKU CH-0562-NG9G7

Yellow PVC tubing rated for fuels, lubricants, beverages and water with a 3/8 in. inside diameter and 10 ft. length

  • ColorYellow
  • Resists hardening and swelling for reliable fuel line performance
  • Meets 3-A and FDA standards for beverage and food contact
  • Withstands 150 °F maximum operating temperature for hot fluid transfer
  • Rated to 20 psi working pressure for low-pressure applications
  • 10 ft length in yellow PVC with .06 in wall thickness

PVC Tubing for Fuel and Beverage Use

This clear yellow PVC tubing measures ten feet long with a three-eighths inch inside diameter and a half inch outside diameter. It is rated for fuels, lubricants, beverages, food and water at a maximum operating pressure of twenty psi and a maximum temperature of one hundred fifty degrees Fahrenheit. The material carries 3-A and FDA standards and has a Shore A hardness of fifty-five.

Suitable for Low-Pressure Fluid Transfer

The tubing suits installers who need a flexible, hardening-resistant line for low-pressure fuel, water or food-grade systems up to twenty psi. It is not for buyers who require higher pressure ratings, larger diameters or materials approved for steam or aggressive chemical service. The wall thickness of point zero six inches limits use to the stated pressure range.

Simple Cut-to-Length Installation

The tubing cuts with a sharp knife or shears and pushes onto barbed fittings secured with clamps. No special tools, solvents or heat are required. The most common issue is kinking if the bend radius is too tight, which can restrict flow or cause the wall to collapse under vacuum.

Highlights

  • Resists hardening and swelling for reliable fuel line performance
  • Meets 3-A and FDA standards for beverage and food contact
  • Withstands 150 °F maximum operating temperature for hot fluid transfer
  • Rated to 20 psi working pressure for low-pressure applications
  • 10 ft length in yellow PVC with .06 in wall thickness

Specifications

ColorYellow
BrandZORO SELECT

Questions about this item

What fittings do I need to connect the 3/8 in ID and 1/2 in OD PVC tubing?

Use barbed or push-to-connect fittings sized for 3/8 inch inside diameter and 1/2 inch outside diameter; the 0.06 in wall thickness matches standard hose barb dimensions.

Will the yellow PVC tubing rated for 20 psi and 150 Degrees F handle the same fuels and lubricants as my existing rubber lines?

The tubing is listed for fuels, lubricants, water and food applications and resists hardening and swelling, so it can replace compatible rubber lines within the 20 psi and 150 Degrees F limits.

How can I verify the 10 ft length and Shore A 55 hardness are correct after I unpack the coil?

Measure the straight length against a tape to confirm 10 ft, then press the wall with a Shore A durometer; a reading near 55 indicates the specified hardness.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.