Usa Sealing
Usa Sealing ZUSA-HT-102 Clear PVC Tubing 1/4" ID x 3/8" OD x 25 ft
Clear PVC tubing for beverage, food and water use, 25 ft long with 1/4 in ID and 3/8 in OD, rated to 20 psi and 140 °F
- ColorClear
- Clear PVC lets you inspect flow visually
- Food-grade PVC rated for beverage and water use
- Shore A 65 hardness balances flexibility with kink resistance
- 25 ft coil covers long runs without joints
- Rated to 140 °F and 20 psi for hot water lines
Clear PVC Tubing for Food and Beverage Lines
This clear PVC tubing is made for food, beverage and water transfer in commercial and home setups. It carries a Shore A 65 hardness rating and is formulated without a jacket. The material meets the requirements for direct contact with consumable liquids.
20 psi Maximum Operating Pressure
The single figure that decides fit is the 20 psi maximum operating pressure at 140 degrees Fahrenheit. Systems that run above this pressure or temperature need a different hose. Always verify your pump and line pressure before ordering.
Push-On Installation Over Barbed Fittings
The 1/4 inch inside diameter slides over standard barbed fittings and is secured with a clamp. No glue, heat or special tools are required. The tubing is not rated for peristaltic pump use, so roller pumps will shorten its life.
Highlights
- Clear PVC lets you inspect flow visually
- Food-grade PVC rated for beverage and water use
- Shore A 65 hardness balances flexibility with kink resistance
- 25 ft coil covers long runs without joints
- Rated to 140 °F and 20 psi for hot water lines
Specifications
| Color | Clear |
|---|---|
| Brand | ZORO SELECT |
Questions about this item
What does the 20 psi pressure rating mean when the tubing is installed in a beverage or water line?
The tubing is rated for a maximum operating pressure of 20 psi, so it will safely handle typical low-pressure beverage dispensing or water supply systems without bursting.
How does the Shore A 65 hardness affect flexibility and kink resistance in a peristaltic pump setup?
With a Shore A 65 hardness the tubing is moderately flexible, but the manufacturer notes it is not compatible with peristaltic pumps, so repeated compression in that application is not recommended.
Will the 1/4 inch inside diameter and 3/8 inch outside diameter fit standard barbed fittings and clamps for a 25 foot run?
The 1/4 inch ID matches common 1/4 inch barbed fittings, while the 3/8 inch OD works with standard hose clamps for secure connections over the full 25 foot length.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Taylor Made 12" x 18" Jolly Roger Novelty Flag 1818 marine electronic
- Accessories



