US Cargo Control
US Cargo Control GVEB34X10 Eye Bolt 3/4 inch 10 inch Shank Steel
A steel eye bolt with a 10 inch shank and 1-1/2 inch inside diameter for heavy-duty lifting and rigging
- TypeScrews & Bolts
- 3/4 inch diameter provides secure anchoring
- 10 inch shank reaches deep mounting points
- 1-1/2 inch eye ID accepts thick hardware
- Steel construction resists deformation under load
- New condition ensures full rated strength
3/4-inch Eye Bolt for Lifting and Rigging
This US Cargo Control eye bolt is a steel fastener with a 10 inch shank and a 1-1/2 inch inside diameter eye. It is designed for straight-line lifting, anchoring or tie-down applications where a forged eye provides a secure attachment point. The product is supplied new and carries a California Proposition 65 notice regarding chemical content.
Suitable for Permanent or Temporary Anchor Points
The bolt suits riggers, maintenance crews and DIY builders who need a single fixed eye for chain, rope or sling connections. It is not intended for angular lifts that exceed the eye bolt's rated alignment, nor for users who require a swivel eye, a shoulder pattern or a threaded shank length other than 10 inches.
Installs into a Matching Tapped Hole or Nut
The shank threads into a compatible 3/4-inch internal thread, so the surrounding structure must provide a properly tapped hole or a through-bolt with a nut. Once secured, the forged eye frees the user from improvised loops or welded brackets, delivering a certified attachment point for hoisting hardware.
Highlights
- 3/4 inch diameter provides secure anchoring
- 10 inch shank reaches deep mounting points
- 1-1/2 inch eye ID accepts thick hardware
- Steel construction resists deformation under load
- New condition ensures full rated strength
Specifications
| Brand | US CARGO CONTROL |
|---|---|
| Type | Screws & Bolts |
Questions about this item
What thread size matches the 3/4 inch eye bolt for installation?
The eye bolt uses a 3/4 inch diameter shank, so you need a matching 3/4 inch threaded hole or nut to secure it properly.
Will the 1-1/2 inch inside diameter accept my existing 1/2 inch shackle pin?
Yes, the 1-1/2 inch inside diameter provides ample clearance for a 1/2 inch shackle pin or similar hardware to pass through freely.
How can I confirm the eye bolt is seated correctly after threading it in?
The shoulder should sit flush against the mounting surface with no visible gap, and the eye should align with the intended load direction.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
