Unitherm
Unitherm Hog Ring Pliers 45 Degrees Red Cushion Grip
Manual hog-ring pliers with a 45-degree angled head and red cushion grip for tight-space upholstery work
- 45-degree angled head reaches tight upholstery spaces
- Spring-return jaws speed up repetitive hog-ring work
- Red cushion grip reduces hand fatigue during long sessions
- Manual feed gives full control over each ring placement
- Steel construction withstands daily farm and ranch use
Hog Ring Pliers for Upholstery
These manual hog ring pliers are built for upholstery installation using 3/4-inch hog rings. The 45-degree head offset gives added access when working in tight spaces around frames or cushions. A red cushion grip on the handles reduces hand fatigue during repetitive fastening tasks. The tool is made from steel and uses a spring-return jaw opening for consistent operation.
Manual Feed Limits Ring Speed
Because the feed type is manual, each ring must be placed by hand before the jaws close. This slows the workflow compared with magazine-fed tools on large projects. The pliers accept only a single ring size and wire diameter of 3/4 inch, so they cannot adapt to smaller or larger fasteners. There is no integrated wire cutter, meaning a separate snip is required to trim excess wire.
Steel Build With Tether Option
The all-steel construction resists deformation when compressing stiff hog rings in dense foam or wooden frames. Spring-return jaws snap back automatically, keeping the rhythm steady during long sessions. The red cushion grip stays secure even with sweaty or gloved hands. The tool is not tether-ready, so a lanyard attachment point would need to be added for overhead or ladder work.
Highlights
- 45-degree angled head reaches tight upholstery spaces
- Spring-return jaws speed up repetitive hog-ring work
- Red cushion grip reduces hand fatigue during long sessions
- Manual feed gives full control over each ring placement
- Steel construction withstands daily farm and ranch use
Specifications
| Brand | Unitherm |
|---|
Questions about this item
How do I decide between the 45-degree offset and a straight-jaw version?
The 45-degree head angle lets you reach around framing and into corners where a straight nose cannot turn, making it the better choice for tight upholstery work.
What does the 45-degree offset actually change when I am fastening rings?
It angles the jaws so you can drive hog rings into recessed seams and around curves without twisting your wrist or forcing the tool.
Does the spring-return jaw limit how fast I can work?
The spring-return action reopens the jaws automatically after each squeeze, so the pace is set by your hand speed, not by a manual reset.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
