Unique-Bargains
Unique-Bargains SMA Male to UHF PL-259 Male RG316 Coax Cable 1.5 ft
Connects SMA and UHF PL-259 devices using 1.5 ft of 50 ohm RG316 coax with nickel-plated bodies and gold-plated brass contacts
- TypeHI - Antennas, Wires & Fittings
- 50 ohm impedance for consistent signal transfer
- 5 ft RG316 cable keeps runs short and tidy
- Double shielding cuts external interference
- Nickel plated connector bodies resist corrosion
- Gold plated brass contacts maintain low resistance
Direct SMA to UHF Link
This 1.5 ft RG316 coaxial cable provides a direct connection between SMA Male and UHF PL-259 Male interfaces. It carries a 50 ohm impedance signal with nickel-plated connector bodies and gold-plated brass contacts for reliable conductivity. The ultra low-loss, double-shielded construction suits RF applications requiring this specific gender pairing.
Installers matching these exact ends
Technicians joining an SMA female port to a UHF female bulkhead or antenna base will find the correct gender combination here. The short length limits placement flexibility, so runs needing extra reach or a different connector pair such as SMA female or BNC male are not served by this assembly.
Fixed 1.5 ft RG316 length
The cable length is set at 1.5 ft and cannot be altered, making this the deciding specification for fit. Buyers must confirm their installation accommodates this exact distance before purchasing.
Highlights
- 50 ohm impedance for consistent signal transfer
- 5 ft RG316 cable keeps runs short and tidy
- Double shielding cuts external interference
- Nickel plated connector bodies resist corrosion
- Gold plated brass contacts maintain low resistance
Specifications
| Brand | Unique Bargains |
|---|---|
| Type | HI - Antennas, Wires & Fittings |
Questions about this item
Will the SMA male and UHF PL-259 male connectors fit my 50 ohm radio equipment?
Both connectors are built for 50 ohm systems; the SMA male uses gold-plated brass contacts and the UHF PL-259 male has a nickel-plated body for a secure match.
How do I attach the cable without damaging the RG316 shielding?
Hand-tighten each connector until the gold-plated contacts seat fully, then give a slight turn with a spanner; over-torquing the nickel-plated bodies can crush the double-shielded RG316 dielectric.
When should I replace this 1.5 ft RG316 jumper?
Inspect the gold-plated contacts and nickel-plated bodies for corrosion or loosening; if the double-shielded RG316 jacket shows kinks, cracks or water ingress, swap the cable to maintain 50 ohm integrity.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Wilson Antennas 305-480 2 ft Silver Load FGT Fiberglass Whip Black antenna
Galtronics 02130269-04935U Indoor Omni Antenna 617-6000MHz 4.3-10 Female
- Antenna
Galtronics 02121269-04935U broadband ceiling mount omni antenna 698-6000MHz
- Antenna mount



