Unique-Bargains
Unique-Bargains Slow Blow Micro Fuse T5A 250V Red 10Pcs
Pack of ten slow-blow micro fuses rated 250V T5A with 8.4mm x 7.7mm bodies and 20mm pins
- Time-delay blow protects circuits from brief surges
- 250 V 5 A rating suits many low-voltage applications
- Compact 8.4 mm x 7.7 mm body fits tight PCB layouts
- 20 mm pins with 4.6 mm spacing simplify through-hole soldering
- Pack of 10 fuses keeps spares on hand for repairs
Pack of ten T5A 250V slow-blow micro fuses
These Unique-Bargains fuses are cartridge-style components rated at 250 volts and 5 amps with a time-delay characteristic. The red cylindrical bodies measure 8.4mm by 7.7mm and have pins 20mm long spaced 4.6mm apart. They are supplied in a pack of ten for circuit-board protection.
For hobbyists and technicians replacing identical
The parts suit anyone repairing equipment that specifies a T5A 250V slow-blow fuse in this exact footprint. They are not for mains plugs, automotive blade holders, or equipment requiring a fast-acting or higher-current device.
Check your board for 4.6mm pin pitch
Verify the existing fuse carries the same T5A 250V marking and that the through-hole spacing matches 4.6mm. Confirm the 20mm pin length clears your board thickness and that the slow-blow action is what the circuit requires.
Highlights
- Time-delay blow protects circuits from brief surges
- 250 V 5 A rating suits many low-voltage applications
- Compact 8.4 mm x 7.7 mm body fits tight PCB layouts
- 20 mm pins with 4.6 mm spacing simplify through-hole soldering
- Pack of 10 fuses keeps spares on hand for repairs
Specifications
| Brand | Unique Bargains |
|---|
Questions about this item
What board hole spacing fits the 4.6 mm pin distance of these fuses?
The pins are spaced 4.6 mm apart so the mounting holes on the PCB must match that pitch.
Will the 8.4 mm diameter body sit beside older 5 mm cartridge fuses on the same board?
The 8.4 mm body is larger than standard 5 mm cartridges so adjacent component clearance needs to be checked.
How do I verify a fuse is good after soldering it in place?
Measure continuity across the pins with a multimeter; a reading near zero ohms shows the element is intact.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
