Unique-Bargains
Unique-Bargains SF8025AT 80x80x25mm DC 110V/120V Dual Ball Bearing Industrial Cooling Fan
An 80 mm square DC 110 V/120 V fan with dual ball bearings delivers 0.5 CFM at 2500 RPM and 30 dB-A
- Compact 80×80×25 mm frame fits tight enclosures
- Dual ball bearings extend operational lifespan
- Low 30 dB-A noise keeps environment quiet
- 2500 RPM delivers 0.5 CFM maximum airflow
- 14 A draw at 110/120 V DC saves energy
80 mm Industrial DC Fan
The Unique-Bargains SF8025AT is an 80 x 80 x 25 mm DC cooling fan rated for 110 V or 120 V operation. It draws 0.14 A and consumes 15.4 W while spinning at 2500 RPM with a ten percent tolerance. Dual ball bearings support continuous industrial use.
Suited for 110/120 V DC systems
This unit fits equipment that supplies 110 V or 120 V DC and has a 73 mm mounting pattern. It is not for builders who need AC mains voltage, higher airflow than 0.5 CFM, or a different frame size. Buyers requiring variable speed control should verify their controller compatibility separately.
Mounting hardware not included
The package contains only the fan itself; screws or brackets for the 73 mm hole spacing must be sourced elsewhere. No software, speed controller or wiring harness is bundled. The bare fan allows integrators to use their preferred connectors and mounting method.
Highlights
- Compact 80×80×25 mm frame fits tight enclosures
- Dual ball bearings extend operational lifespan
- Low 30 dB-A noise keeps environment quiet
- 2500 RPM delivers 0.5 CFM maximum airflow
- 14 A draw at 110/120 V DC saves energy
Specifications
| Brand | Unique Bargains |
|---|
Questions about this item
Does my equipment have a 73 mm mounting pattern to accept this 80 mm fan?
The fan uses a 73 x 73 mm hole spacing, so your chassis or panel must match that pattern for a secure fit.
Will the 2500 RPM speed and 30 dB-A noise level overwhelm an older 110 V DC system?
At 2500 RPM (±10 %) and 30 dB-A the fan runs quietly enough for legacy 110/120 V DC setups without adding noticeable acoustic load.
How can I confirm the fan is spinning at the rated 2500 RPM after installation?
Measure the current draw — it should read about 0.14 A at 110/120 V DC — and verify airflow feels consistent with the 0.5 CFM rating.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
