Vszerda
Vszerda LM4040 Precision Voltage Reference Module 2.048V 4.096V passive component
$17.99
0.00021549BTC
In stock
Unique-Bargains
Unique-Bargains RV24YN 10K Ohm Carbon Film Potentiometer Single Turn 2pcs
Two single-turn 10K ohm carbon-film potentiometers with knurled 6 mm shafts for knob mounting
- FeaturesHorizontal Multiturn Trimmer Potentiometers;Potentiometer Re
- Precise 10K ohm resistance with ±10% tolerance
- 2W power rating handles moderate circuit loads
- Single-turn carbon film gives smooth linear adjustment
- 6mm knurled shaft fits standard push-on knobs
- Pack of two supports stereo or dual-channel builds
Two 10K Ohm Carbon Film Potentiometers
This pack supplies two RV24YN single-turn carbon film potentiometers rated at 10K ohm with a ±10% tolerance and 2W power handling. Each unit has a 6mm knurled shaft 10mm long, a 33.4mm diameter body and three solder terminals for through-hole mounting.
Replaces worn single-turn volume or tone controls
The potentiometers suit repairs where an existing 10K ohm single-turn rotary control has become noisy or lost range. The jump is worth it when the original part matches the 8.7mm thread diameter, 20.5mm total shaft length and 24.4mm body height so the new unit fits the same panel cut-out and knob.
Suits hobbyists repairing audio gear
Builders needing multi-turn precision, a different resistance value, surface-mount footprints or an included knob should look elsewhere. The parts are also unsuitable for high-voltage switching or applications that demand a tighter tolerance than ±10%.
Highlights
- Precise 10K ohm resistance with ±10% tolerance
- 2W power rating handles moderate circuit loads
- Single-turn carbon film gives smooth linear adjustment
- 6mm knurled shaft fits standard push-on knobs
- Pack of two supports stereo or dual-channel builds
Specifications
| Brand | Unique Bargains |
|---|---|
| Features | Horizontal Multiturn Trimmer Potentiometers;Potentiometer Resistor Assortment;Vertical High Precision Variable Resistors;Breadboard Trim Resister ceramic;Assortment Kit for DIY or PCB |
Questions about this item
Will the 8.7 mm screw thread fit my panel cutout?
The potentiometer has an 8.7 mm screw thread diameter. Drill a matching hole in the panel and secure it with the supplied nut.
How do I solder the three terminals without bending the pins?
Insert the three terminals through the PCB holes, keep the body flat against the board, then solder each pin. Avoid forcing the 6 mm shaft sideways while the solder is molten.
When should I replace one of these carbon film potentiometers?
Replace the unit if the resistance track becomes noisy, develops dead spots through the full rotation, or measures outside the ±10 % tolerance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
