Unique-Bargains
Unique-Bargains RP-SMA Male to Female RG174 3 ft 2pcs
Two low-loss RG174 antenna extension cables with RP-SMA connectors extend wireless antennas up to three feet for better placement
- TypeHI - Antennas, Wires & Fittings
- Extends wireless antenna up to 3 ft for optimal placement
- Low-loss RG174 cable with pure copper keeps signal strong
- RP-SMA male to female connectors fit routers and adapters
- 50 ohm impedance matches standard Wi-Fi equipment
- Two cables included for multiple antenna setups
RP-SMA Extension Pair
This two-cable set adds three feet of reach to any removable RP-SMA antenna on a wireless router, access point or adapter. Each cable uses RG174 construction with a pure copper centre conductor for very low signal loss. The 50 ohm impedance matches standard Wi-Fi equipment. Buyers needing longer runs or a different connector type should look elsewhere.
50 ohm Impedance Match
The single specification that determines compatibility is the 50 ohm characteristic impedance, which aligns with common RP-SMA wireless gear. The RP-SMA male plug connects to the device while the RP-SMA female jack accepts the existing antenna. No other impedance value is offered in this listing.
Three-Foot Low-Loss Reach
Each cable extends the antenna by three feet using a .11 inch diameter RG174 jacket that keeps attenuation low for typical indoor Wi-Fi distances. The pair lets you reposition two antennas or keep one spare. Runs that exceed three feet or require outdoor-rated jackets are beyond what this kit provides.
Highlights
- Extends wireless antenna up to 3 ft for optimal placement
- Low-loss RG174 cable with pure copper keeps signal strong
- RP-SMA male to female connectors fit routers and adapters
- 50 ohm impedance matches standard Wi-Fi equipment
- Two cables included for multiple antenna setups
Specifications
| Brand | Unique Bargains |
|---|---|
| Type | HI - Antennas, Wires & Fittings |
Questions about this item
How much signal loss should I expect over the three-foot run?
The cable uses RG174 construction rated at 50 ohm impedance, which keeps attenuation low for typical Wi-Fi router and adapter frequencies.
What connector standard do the ends use?
One end is an RP-SMA male plug and the other is an RP-SMA female jack, matching the removable antennas found on many wireless routers and adapters.
How thick is the cable and will it bend around tight corners?
The outer diameter measures 0.11 inch, so it is thin enough to route through narrow gaps and around equipment without sharp kinks.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Wilson Antennas 305-480 2 ft Silver Load FGT Fiberglass Whip Black antenna
Galtronics 02130269-04935U Indoor Omni Antenna 617-6000MHz 4.3-10 Female
- Antenna
Galtronics 02121269-04935U broadband ceiling mount omni antenna 698-6000MHz
- Antenna mount



