Unique-Bargains
Unique-Bargains RG58 BNC Male to BNC Male Coaxial Cable 50 Ohm 12 ft
A 12 ft RG58 coaxial cable with BNC male connectors on both ends, 50 ohm impedance and 95% braid coverage for low-loss RF connections
- TypeHI - Antennas, Wires & Fittings
- RG58/U low-impedance coax rated at 50 ohm for RF signals
- 95% braid coverage shields against interference
- Nickel-plated connector bodies resist corrosion
- Gold-plated brass contacts ensure reliable conductivity
- 12 ft length with pre-terminated BNC male ends ready to use
RG58 BNC Male Cable 12 ft
This 12 ft RG58 coaxial cable is fitted with BNC male connectors at both ends for direct RF equipment links. It suits technicians, hobbyists and installers who need a ready-made 50 ohm patch lead without field termination.
50 Ohm RG58 Practical Limits
The RG58/U construction with 95% braid coverage and .2 inch diameter carries 50 ohm signals but exhibits higher attenuation than larger-diameter coax at UHF and microwave frequencies. Runs approaching the 16 ft maximum listed length will show measurable insertion loss compared with shorter jumpers.
Before Ordering Check Connector Gender
Verify that both ports on your radios, analysers or antennas accept BNC male plugs; this cable cannot mate with BNC female bulkheads or reverse-polarity variants. Confirm the 12 ft reach suits the physical layout and that 50 ohm impedance matches the system design.
Highlights
- RG58/U low-impedance coax rated at 50 ohm for RF signals
- 95% braid coverage shields against interference
- Nickel-plated connector bodies resist corrosion
- Gold-plated brass contacts ensure reliable conductivity
- 12 ft length with pre-terminated BNC male ends ready to use
Specifications
| Brand | Unique Bargains |
|---|---|
| Type | HI - Antennas, Wires & Fittings |
Questions about this item
Which length should I pick for my setup?
The listing offers this cable in a 12 ft length; other lengths up to 16 ft are available in the same series so you can choose the reach you need.
What does the 50 ohm rating mean for my RF gear?
A 50 ohm impedance matches most common RF equipment, keeping signal reflections low across the 12 ft run.
Will the BNC connectors work with standard BNC ports?
Yes, the nickel-plated bodies and gold-plated brass contacts fit standard BNC female jacks and maintain a solid 50 ohm path.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Wilson Antennas 305-480 2 ft Silver Load FGT Fiberglass Whip Black antenna
Galtronics 02130269-04935U Indoor Omni Antenna 617-6000MHz 4.3-10 Female
- Antenna
Galtronics 02121269-04935U broadband ceiling mount omni antenna 698-6000MHz
- Antenna mount



