Unique-Bargains
Unique-Bargains PTFE Tube 1mm ID 1.4mm OD 1M 3.3ft
PTFE tubing with 1mm inner and 1.4mm outer diameter, 3.3ft length, withstands -70 to 200°C for 3D printer filament guidance
- PTFE material resists chemicals and solvents across demanding environments
- Withstands temperatures from -70 °C to 200 °C for extreme conditions
- Low-friction non-stick surface reduces wear in moving assemblies
- Precise 1 mm inner and 1.4 mm outer diameters ensure consistent fit
- One metre length supplies ample tubing for custom routing
PTFE Guide Tube for 3D Printers
This white PTFE tube has a 1 mm inner diameter and a 1.4 mm outer diameter. It is supplied in a 1 metre length, approximately 3.3 ft. The material is rated for continuous use from -70 °C to 200 °C. It is intended as a low-friction guide for filament in machines such as the CTC 3D Creator, RepRap, Rostock and Kossel.
Users needing a high-temperature.
The tubing suits builders who require a short length of precise 1 mm ID PTFE for a Bowden or direct-drive extruder. It is not for buyers who need a longer continuous run, a different inner diameter, or a material rated above 200 °C.
1 mm inner diameter by 1.4 mm outer diameter
This single dimension set determines whether the tube fits the hot-end and extruder couplers on the target printer. Verify the required ID and OD against the machine's specification before ordering.
Highlights
- PTFE material resists chemicals and solvents across demanding environments
- Withstands temperatures from -70 °C to 200 °C for extreme conditions
- Low-friction non-stick surface reduces wear in moving assemblies
- Precise 1 mm inner and 1.4 mm outer diameters ensure consistent fit
- One metre length supplies ample tubing for custom routing
Specifications
| Brand | Unique Bargains |
|---|
Questions about this item
Does the PTFE material handle continuous high temperatures without degrading?
The tube is rated for temperatures from -70 to 200 degrees centigrade, so it maintains its properties during extended high-heat operation.
Will this tube fit my 3D printer's Bowden system if it requires a 1.4 mm outer diameter?
The tube has an outside diameter of 1.4 mm and an inside diameter of 1 mm, matching systems designed for those dimensions.
Can I use this tubing as a guide for my existing CTC 3D Creator printer?
The product notes it works great as a guide tube for the CTC 3D Creator and is also fit for RepRap Rostock Kossel printers.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
