We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Coiled white polyethylene tubing 7/32 ID 5/16 OD 9.8 ft

Unique-Bargains

Unique-Bargains PE Tubing 7/32 ID x 5/16 OD 9.8 ft White

SKU CH-F08J-EDRY1

White polyethylene tubing, 7/32 in. ID × 5/16 in. OD, 9.8 ft length, rated to 1.0 MPa for pneumatic, drain and chemical-transfer use

  • Lightweight linear low-density polyethylene tubing simplifies handling
  • 7/32 in inner diameter fits pneumatic and lab fittings
  • 8 ft length covers most routing needs
  • Resists stress cracking from chemicals and aging
  • Rated to 1.0 MPa working pressure for pneumatic systems

7/32 ID Polyethylene Tubing for Pneumatic

This 9.8-foot coil of linear low-density polyethylene tubing has a 7/32 inch inner diameter and a 5/16 inch outer diameter. It is intended for pneumatic tools, drain lines, instrumentation, chemical transfer and laboratory process control. The material resists stress cracking from chemicals and aging. It is not approved for food or drinking water applications.

Push-Fit Installation and Common Issues

The tubing slips over barbed or push-to-connect fittings matching the 5/16 inch outer diameter and secures with a clamp or collet. A sharp, square cut prevents leaks; a ragged edge lets fluid bypass the seal. Kinking the line during routing restricts flow and can cause stress cracks over time. Over-pressurising beyond the 1.0 MPa rating risks burst failure.

Compatibility Checks Before Ordering

Verify that your fittings accept a 5/16 inch outer diameter and that the 7/32 inch inner diameter delivers the flow rate your system requires. Confirm the working pressure of your circuit stays within the 1.0 MPa limit. Ensure the media being transferred is compatible with polyethylene and is not a food or potable water product. Measure the run length to confirm a single 9.8-foot coil is sufficient.

Highlights

  • Lightweight linear low-density polyethylene tubing simplifies handling
  • 7/32 in inner diameter fits pneumatic and lab fittings
  • 8 ft length covers most routing needs
  • Resists stress cracking from chemicals and aging
  • Rated to 1.0 MPa working pressure for pneumatic systems

Specifications

BrandUnique Bargains

Questions about this item

How can I verify the 7/32 inch ID tubing is flowing correctly at 1.0 Mpa working pressure?

Pressurise the line to the rated 1.0 Mpa and check for steady flow without leaks or deformation along the 9.8 ft length.

What comes in the package and do I need separate fittings for 5/16 inch OD connections?

The box contains one 3 metre coil of polyethylene tubing; barbed or push-to-connect fittings for 5/16 inch OD must be purchased separately.

Which tubing length should I choose for a 3 metre pneumatic piping run?

The single 9.8 ft (3 metre) coil matches that run exactly; cut to length on site if a shorter section is needed.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.