We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
A pair of double-ended alligator clip test wires in black and red, 1.02m long with insulated clips measuring 58 by 25 by 8mm

Unique-Bargains

Unique-Bargains Pair Double-ended Alligator Clip Test Wire 1.02m

SKU CH-XA5R-KCGAB

A pair of double-ended alligator clip test leads measuring 1.02 metres with fully insulated clips sized 58 by 25 by 8 millimetres for safe multimeter and power-supply connections

  • TypeHI - Test & Measurement Tools
  • Fully insulated clips protect against accidental shorts
  • Double-ended design connects quickly to probes and terminals
  • 02 m length gives ample reach on the bench
  • Black and red colour coding simplifies polarity identification
  • 58 mm clip jaws grip a wide range of component sizes

Pair of double-ended test leads

This pair of double-ended alligator clip test leads provides two ready-made connections for bench work or vehicle diagnostics. Each lead is 1.02 metres long and terminated with insulated clips at both ends. One lead is black and the other red for simple polarity identification. They connect directly to multimeter probes, power supply terminals or component leads.

Replaces loose wires and single-ended probes

The double-ended design removes the need to twist bare wires onto clip jaws or swap probes between test points. It is a practical upgrade when you frequently move a meter between a battery, a fuse block and a sensor harness. The jump is worth it if you want both hands free while the circuit stays connected.

Handles low-voltage continuity and voltage checks

The 1.02 m length reaches across an engine bay or a workbench without strain. Fully insulated boots cover the clip jaws up to the tips, reducing the chance of accidental shorts on tight terminals. They are not suited for high-current starter circuits or mains-voltage measurement.

Highlights

  • Fully insulated clips protect against accidental shorts
  • Double-ended design connects quickly to probes and terminals
  • 02 m length gives ample reach on the bench
  • Black and red colour coding simplifies polarity identification
  • 58 mm clip jaws grip a wide range of component sizes

Specifications

BrandUnique Bargains
TypeHI - Test & Measurement Tools

Questions about this item

What clearance do the 58 × 25 × 8 mm alligator clips need to fit onto a test point?

Each clip measures 58 mm long, 25 mm wide and 8 mm thick, so allow at least that much space around the connection point for the insulated jaws to close fully.

How do I attach the leads to a multimeter without leaving exposed metal?

Push the banana plug on each lead firmly into the meter's input jacks until the insulated boot seats flush; the double-ended clips then connect to the circuit under test with no bare conductor showing.

When should I replace the 1.02 m test leads?

Replace the pair if the red or black insulation shows cracks, the clip springs lose tension, or the banana plugs become loose in the meter jacks, as any of these compromise measurement safety.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.