We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ten flat grey ribbon wires with black female connectors at both ends

Unique-Bargains

Unique-Bargains Female to Female 2P Jumper Wire 2.54mm Pitch 31cm 10pcs

SKU CH-9Y6Z-YBP1J

Ten 31 cm female-to-female jumper wires on a 2.54 mm pitch ribbon that separates for breadboard connections

  • TypeJumper Cable
  • Ready-to-connect female headers speed up breadboard prototyping
  • 31 cm ribbon length reaches across standard boards
  • 3 mm copper conductors carry signals reliably
  • Flat cable separates into single wires for custom routing
  • Pack of 10 pieces covers multiple project needs

Female to Female Jumper Wire 2.54mm Pitch

This pack contains ten 2P female-to-female jumper wires with a 2.54mm pitch and 31cm length. Each ribbon cable uses 1.3mm diameter copper conductors and can be separated for individual connections. The flat ribbon format simplifies wiring on breadboards and prototyping boards. Total cable dimensions are 310mm by 5mm.

Hobbyists and students building breadboard circuits

These wires suit anyone connecting sensors, modules or microcontroller pins on a standard 2.54mm grid. Builders needing male headers, different lengths or shielded cables should look elsewhere. The product is not intended for high-current power distribution or permanent installation in mains-voltage equipment.

Ten pieces give enough leads for small projects

Ten separated wires handle multiple signal paths on a single breadboard layout. Each 31cm lead reaches across a typical board with slack for tidy routing. The ribbon strips apart cleanly, but the 1.3mm conductors limit current to low-power logic levels.

Highlights

  • Ready-to-connect female headers speed up breadboard prototyping
  • 31 cm ribbon length reaches across standard boards
  • 3 mm copper conductors carry signals reliably
  • Flat cable separates into single wires for custom routing
  • Pack of 10 pieces covers multiple project needs

Specifications

BrandUnique Bargains
TypeJumper Cable

Questions about this item

What connectors do I need on my board for these 2.54 mm pitch female ends to plug into?

You need standard 2.54 mm pitch male headers or pins; the female sockets on each jumper accept those directly.

Will these 31 cm ribbons reach across a full-size breadboard while still leaving room for other wiring?

At 31 cm each they span a full breadboard with slack, and the flat ribbon separates cleanly so you can route individual wires around other connections.

How can I verify each of the ten cables conducts properly after I separate them?

Use a multimeter on continuity mode; probe the two female ends of each separated wire — a beep confirms the copper conductor is intact.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.