We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two short BNC male-to-male coaxial cables with nickel bodies and gold contacts

Unique-Bargains

Unique-Bargains BNC Male to Male Coaxial Jumper Cable 50 ohm 6 inch RG174 2pcs

SKU CH-ZF1M-CFZDV

Pair of 50 ohm BNC male-to-male RG174 jumpers, 6 inch with gold-plated contacts

  • TypeHI - Antennas, Wires & Fittings
  • 50 ohm impedance matches RF equipment for clean signal transfer
  • 6 inch length keeps short runs tidy without excess cable
  • RG174 construction with solid centre conductor and tinned copper braid shields against interference
  • Nickel plated bodies and gold plated brass contacts resist corrosion for lasting connectivity
  • Two cables included so you have a spare or can link multiple devices

6-inch BNC Male Jumper Cables

This pair of 6 inch BNC male-to-male coaxial jumpers uses RG174 cable rated at 50 ohm impedance. The 0.11 inch diameter cable features a solid center conductor, dielectric insulation and tinned copper braid beneath a flexible PVC jacket. Nickel-plated connector bodies and gold-plated brass contacts complete the assembly for video, audio or RF signal paths.

Suits bench test leads and tight chassis links

The short length and flexible RG174 construction make these jumpers convenient for instrument interconnections, surveillance camera hooks or broadcast patching where 50 ohm matching is required. Installers needing plenum-rated sheathing, longer reach or a different characteristic impedance should select another cable type. The two-piece pack covers a single connection or provides a spare.

50 ohm impedance on RG174 coaxial cable

The 50 ohm characteristic impedance determines compatibility with test equipment, RF circuits and 50 ohm video distribution systems. Mismatched impedance causes reflections and signal degradation, so verify that the system specifies 50 ohm before installing these jumpers.

Highlights

  • 50 ohm impedance matches RF equipment for clean signal transfer
  • 6 inch length keeps short runs tidy without excess cable
  • RG174 construction with solid centre conductor and tinned copper braid shields against interference
  • Nickel plated bodies and gold plated brass contacts resist corrosion for lasting connectivity
  • Two cables included so you have a spare or can link multiple devices

Specifications

BrandUnique Bargains
TypeHI - Antennas, Wires & Fittings

Questions about this item

What BNC devices are required to connect this 50 ohm jumper cable?

Any equipment with a BNC female port — oscilloscopes, RF test gear, video monitors or antenna feeds — will accept the male plugs on both ends.

Will the RG174 cable work with legacy 50 ohm BNC gear I already own?

Yes, the 50 ohm impedance matches older BNC instruments, and the gold-plated brass contacts maintain reliable continuity with existing female connectors.

How can I verify the 6 inch cables are functioning correctly after installation?

Check for a clean signal on the connected instrument — stable waveform on a scope or clear video on a monitor — and confirm the nickel-plated bodies seat firmly without intermittent loss.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.