We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Aluminium-encased braking resistor, rectangular block with terminals and cable, 33 x 6 x 3 cm

Unique-Bargains

Unique-Bargains Aluminum Encase Braking Resistor 1000W 60ohm

SKU CH-TJ28-PXY3Z

Aluminium-housed braking resistor rated 1000 W at 60 Ω for power supplies, transducers, elevators and load equipment

  • Featurespower supply;transducer;elevator;arena audio;load equipment
  • High 1000 W power handling for demanding braking circuits
  • Compact 33 x 6 x 3 cm aluminium housing saves installation space
  • 60 ohm resistance value suits standard drive and lift applications
  • 32 cm cable with 0.5 cm diameter eases wiring connections
  • 6 cm mounting pitch and 0.4 cm terminal holes simplify secure fixing

Aluminium-cased braking resistor 1000W 60ohm

This aluminium-encased braking resistor dissipates up to 1000W at 60ohm for power supplies, transducers, elevators and load equipment. The compact 33 x 6 x 3cm housing suits installations where space is limited. Multi-connection terminals with 0.4cm inner diameter allow flexible wiring. It is not for buyers who need a different resistance value or power rating.

Thermal and electrical behaviour

The aluminium case transfers heat directly to the surrounding air without a fan, so operation is silent. Continuous 1000W dissipation raises case temperature; adequate airflow around the 33cm length is required. The 60ohm resistance draws current determined by the applied voltage. No active cooling or control electronics are included.

Mounting hardware and wiring

Terminals accept cables up to 0.5cm outer diameter and the 32cm flying leads simplify connection. Mounting pitch is approximately 0.6cm between centres for secure fixing. No brackets, thermal paste or configuration software are supplied. Installers must provide suitable enclosures and protection for the application.

Highlights

  • High 1000 W power handling for demanding braking circuits
  • Compact 33 x 6 x 3 cm aluminium housing saves installation space
  • 60 ohm resistance value suits standard drive and lift applications
  • 32 cm cable with 0.5 cm diameter eases wiring connections
  • 6 cm mounting pitch and 0.4 cm terminal holes simplify secure fixing

Specifications

BrandUnique Bargains
Featurespower supply;transducer;elevator;arena audio;load equipment

Questions about this item

How do I mount the 33 x 6 x 3 cm aluminum-cased resistor and what spacing should I use for the fixing holes?

Drill mounting holes on a 0.6 cm pitch to match the resistor's installation spacing, then secure the case with bolts through those holes; the terminals accept cables up to 0.4 cm inner diameter.

What ongoing checks does the 1000 W 60 ohm braking resistor require after installation?

Periodically verify that terminal screws remain tight, inspect the 32 x 0.5 cm cables for insulation damage, and confirm the aluminum housing is free of dust build-up that could impede heat dissipation.

At what point does the 1000 W continuous rating become the limiting factor during prolonged braking cycles?

The resistor will reach its thermal limit when the average power dissipated exceeds 1000 W; sustained operation above that level causes the aluminum enclosure to overheat and risks resistance drift.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.