Unique-Bargains
Unique-Bargains 9V Battery Clip 15cm Faux Leather
A 9 V battery clip with a faux-leather shell and 15 cm colour-coded leads for DIY soldering
- Faux leather shell protects the clip
- 15 cm stripped and tinned leads for direct soldering
- Red and black wires simplify polarity identification
- Compact size fits tight DIY enclosures
- Simple snap-on operation speeds up battery swaps
Purpose and fit
This 9 V battery clip supplies power to DIY electronics, test rigs and low-voltage prototypes. The 15 cm red and black leads are stripped and tinned for direct soldering or breadboard use. It suits hobbyists and technicians who need a quick, polarised connection to a standard 9 V block. Builders requiring a longer reach or a different connector style should look elsewhere.
Sustained behaviour
The faux-leather shell insulates the snap terminals during continuous low-current operation. Tinned copper wires resist oxidation so contact resistance stays stable over repeated connect and disconnect cycles. No active cooling or thermal management is involved because the component carries only the modest current a 9 V battery can deliver.
Installation notes
Align the snap with the battery terminals and press until it clicks; polarity is fixed by the moulded housing. Strip length is pre-set so solder joints form quickly without trimming. The short 15 cm wires limit routing options in larger enclosures and the clip cannot be re-crimped if a lead breaks.
Highlights
- Faux leather shell protects the clip
- 15 cm stripped and tinned leads for direct soldering
- Red and black wires simplify polarity identification
- Compact size fits tight DIY enclosures
- Simple snap-on operation speeds up battery swaps
Specifications
| Brand | Unique Bargains |
|---|
Questions about this item
Does the 15 cm lead length limit how far the clip can reach inside a tight enclosure?
The 15 cm leads give enough slack to route around small compartments while keeping the connector close to the 9 V battery.
What tools or parts are needed before I can solder these tinned leads to my circuit?
You only need a soldering iron, solder and the target PCB or wires; the leads are already stripped and tinned for direct soldering.
Will this clip fit the same 9 V battery snap used in my older multimeter?
Yes, the standard T-type snap matches the common 9 V block terminals found on legacy meters and other devices.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
