Unique-Bargains
Unique-Bargains 6.5mm 3 Pin Stereo Jack PCB Connector Black
A 6.5 mm three-terminal stereo jack socket for PCB mounting, measuring 34 x 14 x 18 mm and weighing 2.6 g, suited for audio equipment repair
- Panel-mount 6.5 mm stereo jack for secure audio connections
- Three-terminal layout supports balanced or stereo signals
- Compact 34 x 14 x 18 mm footprint fits tight PCB layouts
- Metal-and-plastic construction resists wear in portable devices
- 6 g lightweight design adds minimal mass to mobile gear
6.5 mm stereo jack PCB connector
The Unique-Bargains 6.5 mm 3-pin stereo jack is a panel-mount PCB connector built for audio equipment repair and prototyping. Its metal and plastic construction in silver tone and black suits media players, notebooks, car audio and similar devices needing a replacement jack.
Sustained insertion cycles
The connector uses three metal terminals secured in a plastic housing rated for repeated mating in consumer audio gear. No cycle-life figure is supplied, so designers should verify durability against their own insertion-rate requirements before committing to high-volume production.
Footprint and clearance check
The body measures 34 x 14 x 18 mm with a 6.5 mm bushing diameter; confirm your PCB hole pattern and panel cut-out match these dimensions. Ensure the 2.6 g mass and 1.3 inch length do not interfere with adjacent components or enclosure depth.
Highlights
- Panel-mount 6.5 mm stereo jack for secure audio connections
- Three-terminal layout supports balanced or stereo signals
- Compact 34 x 14 x 18 mm footprint fits tight PCB layouts
- Metal-and-plastic construction resists wear in portable devices
- 6 g lightweight design adds minimal mass to mobile gear
Specifications
| Brand | Unique Bargains |
|---|
Questions about this item
Does the 6.5mm stereo jack generate any noise or heat when powered continuously?
This passive connector has no active circuitry, so it produces no noise, heat or measurable power draw during continuous use.
What tools or equipment are required to mount the 34 x 14 x 18mm PCB connector?
A soldering iron, solder and a PCB drilled to the connector’s 34 mm length and 14 mm width footprint are needed for installation.
Will the 6.5mm jack fit legacy audio gear that uses the same 1/4 inch panel cutout?
Yes, the 6.5 mm (1/4") diameter matches the standard panel cutout used on older amplifiers, mixers and instruments.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
