We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Five 5-pin JST XH female-to-female cables 30cm long

Unique-Bargains

Unique-Bargains 5 Pcs 5Pin 2.54mm Pitch Female to Female JST XH Connector Cable Wire 30cm 12

SKU CH-HDBC-KWD2W

Pack of five female-to-female JST XH cables with 2.54mm pitch and 30cm length for LiPo battery connections

  • TypeHI - Electrical & Industrial Wire
  • Five-piece pack gives spare leads for multiple builds
  • 54mm pitch matches standard JST XH headers
  • 30cm length fits compact chassis routing
  • Female-to-female ends join two male headers directly
  • 24g total weight adds minimal mass to the airframe

What this cable connects

These Unique-Bargains JST XH adapter cables link a five-pin 2.54mm pitch header to a matching female plug. The 30cm length suits internal wiring in RC helicopter models and similar lipo battery packs. Each pack contains five identical cables ready for solder-free assembly.

Replacing loose or custom wiring

The pre-crimped connectors remove the need to hand-crimp 2.54mm pitch terminals for every battery lead. Swapping to these cables is worthwhile when a project demands repeatable, polarised connections without the variability of DIY jumper wires. They also simplify maintenance by letting a pack be unplugged in seconds.

Behaviour during extended use

The plastic housings and copper conductors maintain continuity across repeated connect-disconnect cycles typical of battery swaps. No active cooling or shielding is present, so the cables rely on the low resistance of the short 30cm run to stay cool under normal RC current loads. Physical strain relief is limited to the moulded connector body.

Highlights

  • Five-piece pack gives spare leads for multiple builds
  • 54mm pitch matches standard JST XH headers
  • 30cm length fits compact chassis routing
  • Female-to-female ends join two male headers directly
  • 24g total weight adds minimal mass to the airframe

Specifications

BrandUnique Bargains
TypeHI - Electrical & Industrial Wire

Questions about this item

Will the 2.54mm pitch JST XH connectors fit my existing 5-pin header?

Yes, the 2.54mm pitch matches standard 0.1 inch headers, and each cable has a 5-pin female JST XH connector on both ends.

How do I install these cables without damaging the pins?

Align the keyed female JST XH housing with the male header, then press straight on until the latch clicks; forcing it at an angle bends the 2.54mm spaced pins.

When should I replace one of these 30cm adapter cables?

Replace a cable if the plastic housing cracks, the latch no longer holds, or the wire insulation shows cuts or heat damage near the crimp.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.