Unique-Bargains
Unique-Bargains 3pcs 9V Battery Holder Case with Switch
Holds one 9V battery per case with a built-in on/off switch and 14 cm leads, supplied as a pack of three
- Holds one 9V battery securely with snap-on cover
- 14 cm lead wires give flexible placement options
- Built-in slide switch cuts power without unplugging
- Three holders in one pack for multiple projects
- Rated for 15 W maximum and 2 A continuous current
Compact 9V Battery Holder with Switch
This pack supplies three black plastic holders each sized 6.8 x 3.4 x 2.1cm and fitted with a slide on/off switch and a protective cover. Each unit weighs about 59g total and includes a 14cm two-wire lead for quick connection. The cases accept a single 9V battery (not included) and are intended for low-power projects and test rigs.
Replaces Loose Battery Taping
The integrated switch and pre-stripped wires remove the need for soldering or makeshift insulation when powering small circuits. The jump is worth it when you want a repeatable, tool-free way to connect and disconnect a 9V source without exposing terminals. Maximum continuous draw is rated at 15W or 2A, so the holder suits LED strips, sensors and similar loads but not high-current motors.
Check Voltage and Current Limits
Verify that your circuit stays below the 15W and 2A limits and that the 14cm lead reaches your connection point without strain. Confirm the battery you plan to use does not run excessively hot, as the supplier warns against poor-quality cells. The holder has no built-in regulation or reverse-polarity protection, so ensure your wiring matches the required polarity.
Highlights
- Holds one 9V battery securely with snap-on cover
- 14 cm lead wires give flexible placement options
- Built-in slide switch cuts power without unplugging
- Three holders in one pack for multiple projects
- Rated for 15 W maximum and 2 A continuous current
Specifications
| Brand | Unique Bargains |
|---|
Questions about this item
What are the dimensions and cable length of each 9V battery holder case?
Each holder measures 6.8 x 3.4 x 2.1 cm with a 14 cm cable length.
How do I connect the two wires and avoid the common wiring mistake?
Connect the two wires to your device terminals observing polarity; the slide switch breaks the circuit so ensure the load is wired through the switch, not directly to the battery snap.
When should I replace the plastic case or switch due to wear?
Replace the holder if the plastic cracks, the slide switch becomes loose or fails to click, or the wires show exposed copper near the 14 cm leads.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
