Unique-Bargains
Unique-Bargains 2Pcs Battery Holder 3xAAA ON/OFF Switch
Holds three AAA batteries with a 15 cm lead, an on/off switch and a protective cover
- Holds three AAA cells for portable power
- Built-in on/off switch cuts current instantly
- 15 cm lead wires reach project boards easily
- Compact 63 x 37 x 16 mm case fits tight spaces
- Two holders in one pack for spare or dual setups
Battery holder for three AAA cells
This pack contains two black plastic cases that each accept three 1.5V AAA batteries. A built-in slide switch lets you cut power without removing the cells. Each unit ships with a 15 cm lead terminated in bare wire for direct soldering or connector fitting. The enclosure measures 63 by 37 by 16 mm and weighs about 38 g for the pair.
Suitable for low-power prototypes and toys
Hobbyists powering microcontroller boards, LED strips or small motors will find the 2 A current limit and 10 W ceiling adequate. Builders needing higher current, waterproof enclosures or snap-in PCB mounts should look at other solutions. The open wire ends also mean you must add your own connector or strain relief.
Two-ampere continuous current rating
The supplier specifies a maximum working current of 2 A and a peak power below 10 W. Exceeding either value risks overheating the internal contacts and the attached batteries. Verify your load stays within this envelope before committing the holder to a design.
Highlights
- Holds three AAA cells for portable power
- Built-in on/off switch cuts current instantly
- 15 cm lead wires reach project boards easily
- Compact 63 x 37 x 16 mm case fits tight spaces
- Two holders in one pack for spare or dual setups
Specifications
| Brand | Unique Bargains |
|---|
Questions about this item
Does the holder itself generate noticeable heat when the circuit draws up to 2 A?
The supplier notes the maximum working current is less than 2 A and advises monitoring battery heat during use; the plastic and metal case stays cool under normal loads.
What wire termination do the 15 cm leads have so I can connect them to my project?
Each holder ships with a bare-wire connector on a 15 cm cable, ready to be soldered or inserted into screw terminals.
Will this holder fit alongside legacy 2×AAA compartments in the same enclosure?
The case measures 63 × 37 × 16 mm, so it occupies more length than a typical 2×AAA tray; verify your enclosure has at least 2.5 inches of straight clearance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
