Unique-Bargains
Unique-Bargains 23x16x6mm Carbon Brushes 2pcs for Bosch 180 Angle Grinder
Two 23×16×6 mm carbon brushes with springs and leads to restore motor performance on a Bosch 180 angle grinder
- MaterialMetal
- Fits Bosch 180 angle grinders with 23 x 16 x 6 mm brushes
- Two carbon brushes with leads and springs ready to install
- Replaces worn brushes that cause poor motor running
- Compact 50 mm total length suits tight motor housings
- Light 10 g pair adds minimal weight to the tool
Replacement Brushes for Bosch 180
These carbon motor brushes measure 23 by 16 by 6 millimetres and are designed for the Bosch 180 angle grinder. The pack contains two pieces with wire leads and springs already attached. They are a non-OEM accessory intended to restore a poorly running motor.
Low-Friction Carbon Construction
The graphite material conducts current while minimising commutator wear during normal grinding tasks. Each brush weighs approximately 10 grams and extends 50 millimetres in total length. No active cooling or lubrication is required for typical intermittent use.
Ready-to-Install Pair
Wire leads and brush springs come pre-fitted so no extra hardware is needed for replacement. The grey and silver-tone finish helps identify correct orientation in the holder. Swapping both brushes together keeps motor balance and reduces future downtime.
Highlights
- Fits Bosch 180 angle grinders with 23 x 16 x 6 mm brushes
- Two carbon brushes with leads and springs ready to install
- Replaces worn brushes that cause poor motor running
- Compact 50 mm total length suits tight motor housings
- Light 10 g pair adds minimal weight to the tool
Specifications
| Brand | Unique Bargains |
|---|---|
| Material | Metal |
Questions about this item
How do I install the 23x16x6mm carbon brushes on my Bosch 180 angle grinder, and which step is often missed?
Remove the old brushes from the motor housing, insert the new 23x16x6mm brushes so the wire leads and springs seat correctly, then tighten the brush caps — many people forget to check that the spring sits flat against the brush face.
What maintenance or replacement will these carbon brushes need later?
These 10g brushes wear down with use; when the carbon block shortens to roughly half its original 23mm length, replace both brushes together to keep the motor running evenly.
What limit appears first when the angle grinder runs under sustained load?
The 23x16x6mm carbon brushes heat up and wear faster during long cuts, so brush life becomes the limiting factor before the motor itself overheats.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
