We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small rectangular carbon brush with metal tip black and gold finish 55mm long

Unique-Bargains

Unique-Bargains 13/16" x 11/16" x 5/16" Carbon Brush engine part

SKU CH-RPYT-JCZ48

Carbon brush for electric motors, measuring 55 mm or 2.2 inches overall

  • TypeOther Accessories
  • Fits 13/16" x 11/16" x 5/16" motor slots
  • Carbon and metal construction resists wear
  • 55 mm total length suits many power tools
  • 8 gram weight keeps rotating mass low
  • Single brush replaces worn part in drills and saws

Carbon brush for electric motors

This carbon brush fits generic electric motors in power tools such as rotary hammer drills, circular saws, cut-off saws and angle grinders. It suits hobbyists and repair technicians who need a direct replacement for worn brushes. The 55mm total length and 13/16" x 11/16" x 5/16" profile match many common motor housings.

Capacity and headroom

The brush handles typical intermittent loads found in handheld power tools and small bench equipment. Carbon composition wears gradually under heavy continuous use, so runtime drops once the contact face erodes past the spring tension limit. Users running high-duty cycles should inspect length after each major job.

Single brush in package

The pack contains one carbon brush weighing 8g with a black and gold tone finish. No springs, caps or mounting hardware are included, so buyers must reuse existing hardware or source it separately. This keeps cost low for single-side repairs but requires a second pack for motors that use a pair.

Highlights

  • Fits 13/16" x 11/16" x 5/16" motor slots
  • Carbon and metal construction resists wear
  • 55 mm total length suits many power tools
  • 8 gram weight keeps rotating mass low
  • Single brush replaces worn part in drills and saws

Specifications

BrandUnique Bargains
TypeOther Accessories

Questions about this item

Will the 13/16" x 11/16" x 5/16" carbon brush fit the motor in my older rotary hammer drill?

The brush measures approximately 55 mm total length and is designed for generic electric motors used in rotary hammer drills, circular saws, cut-off saws and angle grinders.

How can I confirm the carbon brush is making proper contact after installation?

The motor should start smoothly, run without excessive sparking at the brush holder and maintain steady power under load.

Does the package include two brushes or only the single 8 g unit shown?

The package contains 1 x carbon brush; a second brush must be purchased separately if your motor requires a pair.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.