Unique-Bargains
Unique-Bargains 10 Pair Power Tool Carbon Brushes 6.5 x 7.5 x 13.5mm for Hitachi
Ten pairs of carbon brushes sized 6.5 x 7.5 x 13.5 mm fit Hitachi drills, grinders, planers and saws
- 10 pairs extend service life across multiple tools
- 5 x 7.5 x 13.5 mm fit Hitachi D10YB, G10SR2, WR16SA and more
- Spring-loaded design maintains contact up to 3.3 cm stretched length
- Carbon composition resists wear in grinders, drills and planers
- Light 28 g pack keeps spares ready without adding bulk
10 Pairs Carbon Brushes for Hitachi Tools
This pack supplies ten pairs of spring-loaded carbon brushes sized 6.5 x 7.5 x 13.5 mm for compatible Hitachi power tools. The brushes suit drills, grinders, planers, saws and nibblers listed by the manufacturer. They are non-OEM replacements intended for routine motor maintenance. Each pair weighs approximately 28 grams total.
Verify Model and Brush Dimensions Before Ordering
Confirm your tool model appears in the compatibility list such as D10YB, G10SR2, G12SA or WR16SA before purchasing. Measure the existing brushes to ensure the 6.5 mm thickness, 7.5 mm width and 13.5 mm length match the worn parts. The spring stretches to roughly 3.3 cm total length when installed.
Steady Wear Under Continuous Motor Load
Carbon material maintains consistent electrical contact during extended grinding, drilling or cutting sessions. The spring mechanism keeps pressure stable as the brush face wears down over time. Ten pairs provide enough spares for multiple service intervals on professional job sites.
Highlights
- 10 pairs extend service life across multiple tools
- 5 x 7.5 x 13.5 mm fit Hitachi D10YB, G10SR2, WR16SA and more
- Spring-loaded design maintains contact up to 3.3 cm stretched length
- Carbon composition resists wear in grinders, drills and planers
- Light 28 g pack keeps spares ready without adding bulk
Specifications
| Brand | Unique Bargains |
|---|
Questions about this item
Does the pack contain 10 pairs of carbon brushes ready to fit, or must springs or holders be purchased separately?
The pack includes 10 pairs of motor carbon brushes with springs attached; no extra springs or holders are required.
How do I confirm the 6.5 x 7.5 x 13.5 mm brushes match my Hitachi tool?
Check your tool’s model against the listed compatibles — G10SR2, G12SR2, DH25PB, WR16SA and others — and verify the old brush measures 6.5 mm thick, 7.5 mm wide and 13.5 mm long.
What does the 3.3 cm total length mean when the brush is installed?
That is the overall length with the spring fully stretched; the carbon block itself is 13.5 mm, so the spring adds the extra reach needed for the holder.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
