Turck
Turck NI15-S30-AD4X 44592 Inductive Sensor M30×1.5 15mm 1065VDC 138g
M30×1.5 threaded inductive sensor detects metal at 15mm range, runs on 1065VDC two-wire DC supply, weighs 138g
- TypeTest Equipment
- Item Count1 pack
- Selling UnitBox
- Parts3 Years
- Labor1 Year
- 15 mm sensing range detects metal without contact
- M30 × 1.5 threaded barrel fits standard mounting holes
- PA12-GF30 plastic housing resists chemicals and impact
- 1065 VDC two-wire DC supply simplifies wiring
- 138 g lightweight sensor reduces fixture load
Sensor for non-flush mounting
The Turck NI15-S30-AD4X 44592 is an inductive proximity sensor with a threaded M30 x 1.5 barrel. It detects metal targets at a rated switching distance of 15 mm without physical contact. The housing uses PA12-GF30 plastic rated for DC 2-wire operation at 1065 VDC. A normally open output switches when a target enters the sensing field.
Upgrade from flush-mount or shorter-range units
This sensor replaces flush-mounted models when the application demands non-flush installation and a 15 mm sensing range. The jump is worth it when the mounting geometry prevents a flush seat or when the target material and speed require the longer operating distance. The 2-wire DC circuit simplifies wiring compared to 3-wire alternatives in the same form factor.
Fits M30 threaded ports with cable routing
The M30 x 1.5 thread installs directly into a matching port or nut without a separate bracket. The integral cable exits the barrel for connection to a PLC input or relay coil. The 138 g weight adds minimal load to the mounting surface. Non-flush mounting requires clear space around the sensing face to avoid metal interference.
Highlights
- 15 mm sensing range detects metal without contact
- M30 × 1.5 threaded barrel fits standard mounting holes
- PA12-GF30 plastic housing resists chemicals and impact
- 1065 VDC two-wire DC supply simplifies wiring
- 138 g lightweight sensor reduces fixture load
Specifications
| Brand | TURCK |
|---|---|
| Model | NI15-S30-AD4X 44592 |
| Type | Test Equipment |
| Item Count | 1 pack |
| Selling Unit | Box |
| Parts | 3 Years |
| Labor | 1 Year |
Questions about this item
What thread size does the M30×1.5 housing need for mounting?
The sensor uses an M30×1.5 threaded barrel, so the mounting hole or nut must match that exact thread pitch and diameter.
How is the DC 2-wire cable connected, and what mistake should be avoided?
Connect the two wires in series with the load and power supply; reversing polarity will prevent the NO contact from switching correctly.
When should the PA12-GF30 housing be inspected or replaced?
Check the plastic housing for cracks or abrasion after heavy vibration or chemical exposure; replace if the M30×1.5 threads show wear that affects the 15 mm switching distance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
