Turck
Turck BIM-M12E-Y1X-H1141 1074003 inductive sensor M12 90 mm 8.2 VDC NAMUR ATEX SIL2
M12 inductive sensor with 90 mm switching distance, NAMUR output at 8.2 VDC, ATEX and SIL2 approved
- TypeTest Equipment
- Item Count1 pack
- Selling UnitBox
- Parts3 Years
- Labor1 Year
- M12 threaded barrel simplifies panel mounting
- 90 mm sensing range covers wide detection zones
- NAMUR output meets DIN EN 60947-5-6 standard
- ATEX and SIL2 approvals support hazardous-area use
- Chrome-plated brass housing resists industrial wear
Industrial magnetic-inductive sensor M12 NAMUR
The Turck BIM-M12E-Y1X-H1141 is a magnetic-inductive proximity sensor built for hazardous-area installations. It carries ATEX gas and dust approvals plus SIL2 functional-safety certification, making it suitable for safety-related circuits in zones where explosive atmospheres may occur.
Suited for NAMUR input modules in safety systems
This device suits engineers wiring NAMUR-compliant input cards on safety PLCs or relay modules that require a two-wire 8.2 VDC signal. It is not intended for installations that demand a standard PNP or NPN switching output, nor for applications that require a non-NAMUR interface or a different barrel thread.
Rated switching distance 90 mm
The sensor achieves its 90 mm rated switching distance only when actuated by the specified DMR31-15-5 magnet; without that magnet the operating distance will be lower. This single figure determines whether the sensor can bridge the required gap in your machine guard or position-detection layout.
Highlights
- M12 threaded barrel simplifies panel mounting
- 90 mm sensing range covers wide detection zones
- NAMUR output meets DIN EN 60947-5-6 standard
- ATEX and SIL2 approvals support hazardous-area use
- Chrome-plated brass housing resists industrial wear
Specifications
| Brand | TURCK |
|---|---|
| Model | BIM-M12E-Y1X-H1141 1074003 |
| Type | Test Equipment |
| Item Count | 1 pack |
| Selling Unit | Box |
| Parts | 3 Years |
| Labor | 1 Year |
Questions about this item
What power supply do I need to run the 8.2 VDC NAMUR output on this M12 sensor?
Provide a DC source that delivers a nominal 8.2 VDC to the two-wire NAMUR loop; the sensor draws its operating current from that same supply.
Will the M12 × 1 connector on this sensor mate with my existing M12 cables?
Yes, the male M12 × 1 connector follows the standard thread and pin spacing, so it fits any compatible M12 female cordset you already use.
How can I verify the 90 mm switching distance is achieved after installation?
Bring the DMR31-15-5 magnet to the sensing face and confirm the NAMUR current shifts at or near the rated 90 mm distance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
