We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Transparent reinforced rubber hose coil 50Ft length

Trident Marine Systems

Trident Marine Systems XHD 1340126 Water Heater Hose 1/2" 50Ft

SKU CH-JME8-Z1QRA

EPDM rubber hose rated 300 psi from -40°F to 212°F for below-waterline intake and discharge

  • ColorTransparent
  • Withstands extreme temperatures from -40°F to 212°F
  • Handles 300 psi pressure for reliable below waterline performance
  • EPDM rubber resists coolants, ozone, cold and heat
  • Polyester reinforced 4-spiral construction exceeds SAE J20R3 standard
  • 50 ft length suits a variety of boat and plant applications

Trident XHD 1340126 Marine Hose

This transparent hose is built for marine water and heater circuits where reliable pressurised flow is required. It suits boat owners and marine technicians fitting below-waterline intake or discharge lines on a variety of vessels. The EPDM rubber construction handles coolant, ozone and temperature extremes from -40°F to 212°F.

300 psi Working Pressure Rating

The single figure that decides fitment is the 300 psi rating, which confirms the hose meets SAE J20R3 for pressurised marine systems. If your installation runs above this pressure the hose is not suitable; if it runs at or below, the four-spiral polyester reinforcement provides the needed safety margin.

Simple Cut-and-Clamp Installation

Installation is a matter of cutting the 50 ft coil to length and securing each end with appropriate marine-grade clamps. The most common issue is using undersized clamps or routing the hose too tightly against sharp edges, which can abrade the cover and cause premature leaks.

Highlights

  • Withstands extreme temperatures from -40°F to 212°F
  • Handles 300 psi pressure for reliable below waterline performance
  • EPDM rubber resists coolants, ozone, cold and heat
  • Polyester reinforced 4-spiral construction exceeds SAE J20R3 standard
  • 50 ft length suits a variety of boat and plant applications

Specifications

ColorTransparent
BrandTRIDENT HOSE

Questions about this item

What does the 300 psi rating mean once the hose is installed on my boat?

It means the hose can safely handle up to 300 psi of working pressure in pressurised water or heater circuits without bursting.

How does the SAE J20R3 rating affect what coolants or temperatures I can run through it?

The hose meets SAE J20R3, so it resists standard marine coolants, ozone, and temperatures from -40°F to 212°F in service.

What fittings or clamps do I need for the 1/2 inch inside diameter?

Use 1/2 inch barbed or beaded hose fittings secured with stainless-steel worm-drive clamps sized for 1/2 inch ID hose.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.