TMG
TMG 94ALF20701 lead-free brass ball valve
Lead-free forged brass ball valve with quarter-turn lever handle for plumbing, HVAC and fire-protection systems
- Lead-free forged brass suits potable water systems
- Quarter-turn lever handle gives fast flow control
- Forged brass body resists corrosion in plumbing use
- Certified for fire protection and HVAC applications
- TMG 94ALF20701 model built for general plumbing reliability
Lead-free forged brass valve
The TMG 94ALF20701 is a lead-free forged brass ball valve built for reliable flow control. It suits fire protection, general plumbing and HVAC systems including potable water lines. Quarter-turn lever handle operation gives quick on-off action with minimal effort. The design targets installers who need dependable shut-off without premium cost.
Sweat-to-sweat connection upgrade
This valve replaces older threaded or compression fittings where a permanent sweat-to-sweat joint is preferred. The jump is worth it when soldered connections are specified by code or when leak-free permanence outweighs serviceability. It eliminates the need for thread sealant and reduces potential leak paths at the joint. The forged brass body resists dezincification better than many cast alternatives in aggressive water.
Fits copper piping systems
The valve integrates directly into copper pipe runs using standard soldering practice. It needs clean, fluxed copper tube ends and a torch for installation. Once fitted it frees up maintenance time by providing a robust quarter-turn shut-off that does not require packing adjustments. No special tools beyond normal plumbing kit are required for the joint.
Highlights
- Lead-free forged brass suits potable water systems
- Quarter-turn lever handle gives fast flow control
- Forged brass body resists corrosion in plumbing use
- Certified for fire protection and HVAC applications
- TMG 94ALF20701 model built for general plumbing reliability
Specifications
| Brand | TMG |
|---|
Questions about this item
What pipe diameter does the 1-1/2 in. sweat connection fit?
The valve uses 1-1/2 inch sweat-to-sweat ends that solder directly onto copper tubing of the same nominal size.
Which step is often missed when soldering the 94ALFTMG Series valve?
Remove the PTFE seats and stem assembly before heating so the solder joint does not damage the internal seals.
When should the PTFE seat kit be replaced on this lead-free brass ball valve?
Replace the seat kit if the quarter-turn lever handle begins to leak or requires excessive torque to operate.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
