We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver pillow block bearing housing with two bolt holes and a 2-7/16 inch bore

Timken

Timken Pillow Block Bearing 2-7/16" Bore 5/8" Size

SKU CH-K56H-VX0YW

A pillow block ball bearing with a 2-7/16 inch bore and two-bolt mounting

  • Size5/8"
  • 2-7/16" bore fits large shafts for secure mounting
  • Two-bolt design simplifies installation and alignment
  • Ball bearing construction reduces friction for smooth rotation
  • 5/8" size matches standard hardware for easy replacement
  • New condition ensures full service life from first use

Pillow Block Bearing for 2-7/16" Shafts

This pillow block bearing supports a 2-7/16 inch bore shaft with a ball bearing insert. The two-bolt mounting pattern secures the housing to flat surfaces in conveyor, fan or agricultural equipment. It is supplied new and ready for installation in light-to-moderate duty applications.

Behaviour Under Sustained Load

The ball bearing design handles continuous radial loads while the pillow block housing distributes force across both mounting bolts. Regular lubrication intervals maintain low friction and prevent premature wear during extended run periods. Operating temperature and contamination levels directly affect service life in heavy-duty cycles.

Practical Limits of the 5/8" Specification

The 5/8 inch size designation defines the critical fit envelope for this bearing series. Shaft tolerances outside the intended range will cause excessive clearance or interference that degrades performance. Installers must verify shaft diameter and housing alignment before final tightening of the two mounting bolts.

Highlights

  • 2-7/16" bore fits large shafts for secure mounting
  • Two-bolt design simplifies installation and alignment
  • Ball bearing construction reduces friction for smooth rotation
  • 5/8" size matches standard hardware for easy replacement
  • New condition ensures full service life from first use

Specifications

Size5/8"

Questions about this item

Does the pillow block bearing generate noticeable heat or noise when running continuously?

The ball bearing design typically runs quietly with minimal heat buildup under normal operating conditions.

What mounting hardware is required to install the 2-7/16" bore pillow block bearing?

Two bolts are needed to secure the unit to a flat mounting surface.

Will the 5/8" size specification match existing shafts on older equipment?

The 5/8" dimension refers to a specific feature; verify your shaft diameter and housing fit before installation.

More in Misc Hardware

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.